Electronics Forum | Tue Aug 24 03:36:19 EDT 2010 | naveed
Hi all!i m using yv100xg line,with vois application version 1.5R2000,when the mechine starts,after loading all files and returning to origin,a mesg appears ,that iz"Ea12324:the repair detection of the file.the mchne is unusually finished and it has t
Electronics Forum | Mon Sep 06 08:38:54 EDT 2010 | sachu_70
I am impressed to know that you are a one-man army confronting YV100Xg. However, you could always call in for an Engineer from a YAMAHA service provider to resolve your problem. Else, just try by reinstalling your machine software. But before you do
Electronics Forum | Fri Sep 17 03:03:29 EDT 2010 | grahamcooper22
Hi Gani, looking at the HASL icture and the poor wetting of the solder over the pads I would imagine that the HASL coating is very thin on the pads and in actual fact isn't 'solder' but is tin /copper intemetallic and this has poor solderability. It
Electronics Forum | Fri Sep 24 16:01:07 EDT 2010 | dougt
I remember this problem but can't remember exactly what the reason was. It might have been the wrong pullup resistor on the MEI interface board used for the home photo on the y axis. You are right, after a couple hours the machine would work fine.
Electronics Forum | Mon Sep 20 11:58:22 EDT 2010 | dman97
Hi, I was wondering if anybody knows of a way to close the hood on a 265gsx after it has been opened and the machine has been shut down? What I’m trying to say is that the machine was shut down with the hood raised and the prop rod on. When I boot
Electronics Forum | Fri Sep 24 06:17:47 EDT 2010 | bullyparade
Hi all, we use a MPM UP2000/B printer and facing the following problem: During startup/initialisation process the printer stops after a while and comes up with the following alarm "hardware limit warning". This can be repeated several times with the
Electronics Forum | Wed Sep 29 11:25:49 EDT 2010 | mazjal7
Hi, We are placing a Surface Mount connector on a flex circuit, we are planing on using SMT carriers to support the flex through the SMT process. Underneath the connector a stiffener needs to be adhere, I'm not sure if we should have the flex manu
Electronics Forum | Sun Oct 03 13:32:54 EDT 2010 | schen
Hi. there's no other way to do except hand solder the top side cap or using hand print hand place method during SMT process. otherwise you will have to spend more time just to set up this process. bottom line is you have to install this one cap first
Electronics Forum | Mon Oct 04 15:10:42 EDT 2010 | 18424
Hi Michelle, Due to the dense population of through hole on some boards, after a 35 minute wash, some connectors or battery holders remain wet. Currently we put them into drying ovens at 70c for a Minimum of a half hour. We do occasionally air dry un
Electronics Forum | Fri Oct 29 11:23:51 EDT 2010 | pfloh
Just for your reference. If you need to check for surface contamination, then we shall go for microscope inspection at different modes. But this will not reflect on actual PCB performance. Solderability test will still a good option if PCBA is expe