Electronics Forum | Fri Sep 10 00:02:14 EDT 2004 | Darren
Dror, If I understand your question correctly, you would like to know what the operators should be doing in what priority during setup or changeover? Simply stated if you are doing on line setup due to limitations in feeder quantity or manpower avail
Electronics Forum | Thu Aug 26 00:27:45 EDT 2004 | valuems
There is so much confusion about this cognex not reconized statement, and it's time to step in. The box on the out side is a cognex 2000 system. The reason for the cognex not reconized statement is very simple. MPM wrote the 4.1y software looking
Electronics Forum | Tue Aug 31 13:23:37 EDT 2004 | frankracine
Thanks Ken for your reply. Concerning OSP, there are a few negative points that I must considered for our application. I've read all the following points in an Entek document. Never test it. - If you have a miss print and you clean the PCB, the co
Electronics Forum | Thu Sep 02 10:24:35 EDT 2004 | dj_jago
Greetings from the UK: I have been quite fortunate to lead (no pun intended) our company towards lead free sooner rater than later. One of our customers produces a product which is refurbushed every 6 months or so and sent back into the market. A
Electronics Forum | Thu Sep 02 14:02:49 EDT 2004 | russ
Frank, We are currently running lead free for approximately 1 yr. now but no where near the volumes you have mentioned. We are about 5k units per month. I personally am in agreement with you as far as OSP. I also do not like white tin finish since
Electronics Forum | Thu Sep 16 21:22:39 EDT 2004 | Darby
Cesar, I am not familiar with these machines but I have found that servo controller problems do not usually cause mis-placement. They tend to just stop the machine with *axis system erors. As I understand it, after you have done a return to origin,
Electronics Forum | Tue Sep 21 16:09:08 EDT 2004 | davef
Q1: What is "enough surface free energy"? A1: Look here for background: http://www.azom.com/details.asp?ArticleID=1575 Q2: How do I determine surface free energy? A2: We look at it a relative term. For instance, a semi matte finish on solder mask
Electronics Forum | Fri Sep 24 11:08:13 EDT 2004 | davef
We're not sure what you mean by temperature sensitive components. From an assembly process stand-point, every component we use is temperature sensitive to one level or another. More specifically, some of our products use polyphenylene sulfide (PPS)
Electronics Forum | Sun Oct 10 00:47:01 EDT 2004 | Grant
Hi, I checked one out in Taiwan recently, and they had two NXT systems on the booth. I think they are very exciting, and being able to change the mounter head and camera, and dual lane is good for through put. However each bay is only 20 x 8mm feed
Electronics Forum | Fri Oct 29 15:24:32 EDT 2004 | glaucon
Do a little bit of digging in the following areas: - Service/Support in China; How good or how bad is it? - Ease of use; can the operators harness all the features? or will you be baby-sitting them? - Access to parts/spares pricing...follows under t