Electronics Forum | Tue Aug 29 07:40:20 EDT 2006 | CL
Good Morning SWAG, We have the same situation. We have found that for the most part, bottomside components do not move from thier location durring reflow unless pressure is applied. We have had instances where the component is able to drop down into
Electronics Forum | Fri Mar 02 09:19:31 EST 2007 | Rob
Hi all, We are looking at putting cutting boards into our goods in area - for opening sealed bags to check the contents and to aid in decanting, and would appreciate any relevant input. The components should never come into direct contact with thes
Electronics Forum | Wed Mar 07 11:59:54 EST 2007 | Robbie
Hi all, > > We are looking at putting cutting > boards into our goods in area - for opening > sealed bags to check the contents and to aid in > decanting, and would appreciate any relevant > input. > > The components should never come into > d
Electronics Forum | Tue Mar 13 08:04:28 EDT 2007 | Cmiller
We have used thousands of them with no problems. They will not aid in "connector retention" unless you have a shear force at exactly the right angle. This is an advertising joke. They will help with alignment of the connector. Open your holes up so t
Electronics Forum | Thu Dec 06 14:59:50 EST 2007 | ch
Hi All! Thinking about purchasing 2nd user Panasonic p&p machines (CM88s-M1 or MSR series...) but I didn�t know anything about it�s programming. So, I wonder do I have to use any off-line software by anyway or it is possible just to load centroid dat
Electronics Forum | Tue Feb 26 17:00:15 EST 2008 | slthomas
I haven't had the luxury of machine based pth assembly in quite a while, but when I did, given that the machines control which parts are inserted (and to a lesser degree where they are inserted) we decided not to perform inspection on that part of th
Electronics Forum | Thu May 01 10:51:09 EDT 2008 | realchunks
You need a paste designed specifically for this. They are available. Most have 2% silver in them and higher temp flux so you can reflow at "no-lead" temps. The silver aids in the intermaetalic bond and the high temp flux allows you to reflow the n
Electronics Forum | Thu Oct 02 17:00:44 EDT 2008 | davef
Is that accurate? If so, what are your aspect & area ratios? [Similar to the JerryS comment above.] * You say, � � and the average height is very high: nearly 200 pct.� => Our troop can make paste that height too. They snap the stencil-off a fast as
Electronics Forum | Tue Mar 24 09:04:33 EDT 2009 | sachu_70
External CO2 extinguishers certainly help. But requires the alertness of a trained personnel to use the same effectively during a fire. I have also come across a solution wherein the extinguisher is kept always connected to continuously deliver pres
Electronics Forum | Fri Aug 07 07:55:30 EDT 2009 | robhs
Hi. We are planning a production run of a board that utilises the SEMTECH SLP2710P8 8-pin device (2.7 x 1.0 x 0.58mm). The part orientation on the board necessitates that the squeegee print direction approaches the stencil apertures on the long side