Electronics Forum | Tue Aug 13 09:41:03 EDT 2013 | horchak
If it's forced air convection I'd check all the circulating fans and filters. Also if its a clam shell bonnet make sure it's closed all the way and the seal is good. You didn't specify whether it is one zone or the full length of the oven, I do not w
Electronics Forum | Tue Aug 13 10:22:13 EDT 2013 | mccabekev
We are seeing this the full length of the oven. We run a lot of double sided boards, so we cannot run them on the wire mesh. I checked inside the oven to ensure there was no build up of dropped parts that could block it. The temperature difference
Electronics Forum | Fri Aug 30 02:12:19 EDT 2013 | raqz
Hi! I have been studying the reflow process. And now, I am researching for a recommended reflow oven that can process a small to low-medium production SMT soldering. For the experts in the reflow field, please recommend a reliable reflow oven. Here
Electronics Forum | Mon Mar 24 15:20:15 EDT 2014 | kojotssss
Hello for all People's .I have a question. I have a problems with backup pin placement.When x/y robot tried to set up pins: we got a problem- X=-0.200 and y=-0.880 To my mind ther are a problem with air cylinder and axis.Any solutions?! can you c
Electronics Forum | Wed Apr 09 03:32:49 EDT 2014 | sarason
Place a Digital CRO on that 24V rail. Watch the output. trigger on voltage drop lets say 18V picking a figure out of the air. You may well have another rail in your supply or nearby pulling your 240V //110V rail. Most likely a shot Electro either on
Electronics Forum | Fri Jun 13 11:28:40 EDT 2014 | jimmyboz
There is a small cylindrical sensor on the air cylinder that that actuates the chuck. I can't remember if there are one or two. Its (they) are about 4mm x 20mm and I think (it) they have a signal light. Make sure it is mechanically working properl
Electronics Forum | Wed Sep 03 06:05:49 EDT 2014 | cunningham
We use the PDR machine. Great bit of kit. We prefer it due to the IR heating on the top. No air is used to potentially blow neighbouring components that go into secondery reflow off the board. We have a Zevac to but thats not as good. Camera is
Electronics Forum | Thu Feb 26 12:24:02 EST 2015 | emeto
The best test will be to X-ray BGA under 3-D X-ray. About the techniques used for BGA repair you can probably take closer look to some BGA repair stations, even though I have seen it done with hot air gun in the early days.
Electronics Forum | Tue Jun 09 14:10:41 EDT 2015 | duchoang
Last time I used Topaz X2 was 5 years ago. Correct me if I'm wrong. There are some reasons: -Head dirty so machine thought there was nozzle on head already. -Nozzle changer/ Nozzle position offset. -Something jammed and nozzle changer can not go all
Electronics Forum | Wed May 13 15:26:45 EDT 2015 | cyber_wolf
We are high mix - high changeover aerospace manufacturer. We have 3 1809 MK3 air ovens. There has been absolutely no issues with them. We have 4 MPM Momentums. I looked at DEK but felt the MPM's were put together better. They are very easy to use