Electronics Forum | Tue Jun 01 08:30:51 EDT 1999 | Dave F
| I have difficulty to convince my management to air-condition our manufacturing facilities. The room temperature fluxuates from 8 deg.C in the morning to 25 deg. C in the afternoon. The PCB topside temperatures in the reflow oven and wave soldering
Electronics Forum | Thu Jun 03 18:53:27 EDT 1999 | Raeto Zryd
| | I have difficulty to convince my management to air-condition our manufacturing facilities. The room temperature fluxuates from 8 deg.C in the morning to 25 deg. C in the afternoon. The PCB topside temperatures in the reflow oven and wave solderin
Electronics Forum | Wed May 26 15:02:40 EDT 1999 | Paul Bonstrom (SGI)
Looking for help in finding suitable high temp gasket for use in smt assy support application. Gasket used to restrain flex on smt module in area prone to localized heating due to nearby device removal (hot air). Current gasket mtl (neoprene) degra
Electronics Forum | Mon May 03 10:08:41 EDT 1999 | Cunli Jia @ SMTnet
| Why don't you publish this in SMTnet papers? I'm sure many would be interested in reading it. You have written many of the papers have written have broad interest. Thanks. Dave F Dave: Thank you for the suggestion. Bob: We would very much lik
Electronics Forum | Sat Mar 20 00:23:39 EST 1999 | Mikec
| We have been evaluating a trial copy of FujiCAM for several months. Are there any other users of FujiCAM out there that would be willing to share experiences. | I have had it installed for about a month. Aside from a few bugs (new revision du
Electronics Forum | Thu Mar 25 02:03:49 EST 1999 | Stoney Tsai
| | We have been evaluating a trial copy of FujiCAM for several months. Are there any other users of FujiCAM out there that would be willing to share experiences. | | | I have had it installed for about a month. Aside from a few bugs | (new rev
Electronics Forum | Mon Mar 15 20:13:10 EST 1999 | Wayne Bracy
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Tue Mar 16 22:28:48 EST 1999 | Bryan Beaumont
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Tue Mar 09 07:06:42 EST 1999 | Charles Stringer
| | | | I need to setup an oven to run with a nitrogen atmosphere for | | boards with BGA's, but our ovens do not have the optional atmosphere monitor and controller. Is there a good way to sample and control the atmosphere without the optional bui
Electronics Forum | Thu Mar 04 14:20:48 EST 1999 | Greg Valdman
| For as much as you can minimize bridging in these condition by changing board orientation, the only way to eliminate them may be to add debridging airknife tech to your system, or purchase a system that is fitted with this technology. We have been