Electronics Forum: air pressure (Page 1 of 29)

DEK 265 GSX air conditioner refrigerant pressure

Electronics Forum | Fri Apr 27 02:17:37 EDT 2018 | bukas

hello everyone, I have issue with one of my DEK air conditioners, it starts to freeze soon after we turn it on. most probable cause is low air flow or low refrigerant pressure. does anyone know what is operating refrigerant pressure range for DEK ai

DEK 265 GSX air conditioner refrigerant pressure

Electronics Forum | Fri Apr 27 09:41:44 EDT 2018 | cyber_wolf

Typically freezing and air conditioners equals a low charge.

DEK 265 GSX air conditioner refrigerant pressure

Electronics Forum | Sat Mar 30 13:33:50 EDT 2019 | stephendo

This is not an HVAC unit. This is a small unit attached to a production machine to keep the solder paste from drying out prematurely or slumping. The volume of air being cooled and desicated would be less than 3 or 4 cubic meters.

DEK 265 GSX air conditioner refrigerant pressure

Electronics Forum | Sat Mar 30 03:34:44 EDT 2019 | jacoblemaster

Are you still facing this issue? Well, I am so late to get to know this. I think you first check your evaporator coil if your air conditioner is still freezing up. It has been seen that a dirty airflow coil stops the proper flow of air through it. It

Compressor air line material

Electronics Forum | Mon Jun 25 09:59:41 EDT 2007 | slthomas

Plastic of any kind for compressed air is a code violation here. It's not just the pressure, it's the durability. PVC is pretty brittle and if you smack it with a pallet jack it's a lot more likely to shatter and generate high speed shrapnel than cop

Compressor air line material

Electronics Forum | Mon Jun 25 09:29:04 EDT 2007 | swag

Copper is best! I've seen troubles with black pipe - the pipe is not always clean on the inside and debris or mill scale makes it into your equip. eventually. We've also used PVC to get by/quick fix and we always ended up blowing a fitting or even

smt plant air quality

Electronics Forum | Tue Jun 05 20:25:27 EDT 2001 | davef

Sorry that I'm so late responding. Your new additon probably has 'backee stains on the floor already. Assuming we're talking about a fairly standard board assembly area, you don't need to specify air quality. 1 We specify * Particulate: Level to b

Standard for Stencil printers edges pressure

Electronics Forum | Tue Apr 18 17:59:07 EDT 2006 | karenp

Hi guys: I'm trying to get the recommended pressure for stencil edges using air compression, I'm working with I-source but they don't have any standard like IPC or something that can help me to use and decrease the replacement of stencil because of

Standard for Stencil printers edges pressure

Electronics Forum | Wed Apr 19 20:33:14 EDT 2006 | davef

I just flew in from (insert city) and boy are my arms tired. pr: Likely, you're correct. The "pound-inch" units should have been the give-away, for us. Good catch. If this is the case, the frame fabricator would be the best source for tensioning

Spray fluxing, How much air pressure?

Electronics Forum | Mon Oct 16 16:01:42 EDT 2006 | timnop

I have a wave machine (offshore made) with internal spray fluxer configured with a conventional spray gun set up. In order to spray fluid (in this case, flux) I must set the air pressure at 0.3 mPA (43 PSI). At that pressure, my flux sprayer creates

  1 2 3 4 5 6 7 8 9 10 Next

air pressure searches for Companies, Equipment, Machines, Suppliers & Information