Electronics Forum | Fri Aug 19 08:32:54 EDT 2022 | angela t
The GKG G5 press has occasional drive alarms, sometimes it turns off and restarts, sometimes it needs to be unplugged from the board cable at the back and the alarm returns after a period of production. What is the problem? Could any of you give me a
Electronics Forum | Fri Aug 26 01:46:04 EDT 2022 | angela t
The drive and power supply were checked and were fine, but later I found that there was a problem with the J22 cable, which would alarm if I touched it. I suspected that the cable was damaged and planned to buy a replacement cable to try.
Electronics Forum | Wed Nov 03 12:57:28 EDT 2010 | adrianam
I need some help with the following alarm appeared on Fuji FCP4-3 : ,,Servo Amplifier alarm on X, Y, C, Z axis". When I push the reset button, remain ,,Servo Amplifier Alarm on D, F theta axis". All the sensors and solenoid it were checked and is OK
Electronics Forum | Thu Apr 26 02:32:44 EDT 2018 | bukas
1. check both e-stop buttons are released 2. reset e-stop with blue reset button 3. open Alarms menu(there is icon) 4. acknowledge alarms(next to alarms menu icon) 5. clear alarms(next to acknowledge alarms icon) 6. go back to operating interface(thi
Electronics Forum | Tue Mar 05 12:00:00 EST 2013 | aj
do you have an error alarm code on the actual servoe itself?
Electronics Forum | Mon Sep 14 16:36:40 EDT 2015 | simons
Upon start up our QSA machine is giving us the following errors. Cant reset motor alarm (x axis) Cant reset motor alarm (y axis) Cant reset motor alarm (z axis) What are the possible reasons for this? Thanks
Electronics Forum | Tue Mar 30 14:59:00 EST 2004 | Claude_Couture
no help from BTU, didn't buy from them so no support. I found the cause of the problem. The input of the controler relating to the conveyor alarm must have been stuck. By toggling the trigger value from Lo to High in the setup screen, I caused an ala
Electronics Forum | Wed Dec 12 19:37:52 EST 2007 | marcelll
On a old VIP 98 oven. Since we reload the software, we have a problem with the board tracking system. Board is flagging the entrance pcell, we can see it on the graphic screen, but alarming all the time when at exit end. Alarm is "board droped in ove
Electronics Forum | Fri Oct 15 16:52:52 EDT 2010 | wingding
Fuji IP2: I am having problems with an MTU Cycle Alarm error. There is no such error listed in the IP2 manual or the MTU manual. It sometimes comes up while placing parts on a board or sometimes right after Zero Set. Does anyone know what generates t
Electronics Forum | Fri Jan 12 09:22:51 EST 2018 | dskling
Hello We have a Vitronics XPM820 that has us stumped. We have replaced both power supplies (G1 and G2) and we still cannot clear this alarm. The A1 board has all 4 leds light for proper voltages. We have verified that we are getting the correct vo
