Electronics Forum | Sat Feb 05 21:58:08 EST 2000 | Stu Leech
I agree with all of the previous comments. 1) Here are a few things to keep in mind when cleaning with water. To effectively clean, any liquid must wet the surface. By itself, water has a surface tension of 70 dynes/square cm. This is relaively hig
Electronics Forum | Mon Jan 31 14:08:26 EST 2000 | Ashok Dhawan
I have got a number of assemblies back from a customer with feedback that the solder fillet is less than 25% of chip height per IPC-Standard-610B Class 2. Most of my joints are having good wetting but fillet height does not meet min ht requirement of
Electronics Forum | Wed Jan 26 12:48:56 EST 2000 | Wolfgang Busko
What does easy to use mean? From operators view: - simple input menue - precise error messages with suggestions what to check first - trustable feeders - low noise - feederchange possible without stop - automatic pickup-position alignment - safety fe
Electronics Forum | Fri Jan 21 19:27:54 EST 2000 | Scott S. Snider
With the Siemens line computer it is possible to see what the maximum placements per hours should be for any given job/setup. After you optimize the job you should check that and see how you perform against that number. In many cases the placements
Electronics Forum | Mon Jan 31 13:34:43 EST 2000 | PAUL WOOD
HELLO CUSTOMERS OF OK LATEST INFORMATION UPDATE WITH REFERENCE TO OLD BGA 2000 MACHINES WHICH ARE NOW 6YEARS OLD MANY NEW INVENTIONS WHICH HAVE TAKEN PLACE CAN BE PURCHASED FROM METCAL TO BRING YOU TO THE FOREFRONT OF TECHNOLOGY.(PATENTED TO ) BGA 30
Electronics Forum | Tue Jan 25 13:15:17 EST 2000 | Michael Allen
Thanks for the input Mike (and others). As you guessed, via-in-pad is not my idea, and I'm resisting it as much as I can. One of our designers used this practice at some other company, says there were no problems, and wants to use it (via-in-pad) a
Electronics Forum | Mon Jan 17 12:16:02 EST 2000 | Brian W.
My old company (CM) ran SMT to 50ppm including some very complex boards. We established the normalizer number by: #components + #solder joints. As was stated earlier, the ppm for any given product is the result of many factors. You may get differen
Electronics Forum | Tue Jan 18 03:00:23 EST 2000 | cklau
Hi there; CAD s/w and h/w are very expensive investment these day's , exspecially for EDA(Electronic Design Automation).Since that many of the CAD data is not compatible to each other format then it is very important that they choose the right one.H
Electronics Forum | Sat Jan 08 11:12:49 EST 2000 | S. Evers
Hi all, Best Thing Since Sliced Bread? No doubt many of you have seen Phil Zarrow's "over-the-top" review in Circuits Assembly of the new Ersa scope, a device that allows viewing a really neat close up a side view of the component substrate interface
Electronics Forum | Wed Jan 12 20:20:54 EST 2000 | Bene
I had the opportunity to spend time with a demo and one on one with the inventor of the Ersa scope inhouse a few months ago. I see the scope complimenting X-ray inspection but not as a substitue. It allows you to view attributes of a solder joint t