Electronics Forum | Mon Nov 24 19:21:04 EST 2003 | alwil
Hi, I have seen this problem. Make sure that the peeler tape goes round all three pulleys as in the diagram on the feeder. Make sure the feeder clutch is oil free and not slipping. If everything is set correctly then it may be a component vendor i
Electronics Forum | Thu Aug 17 11:32:39 EDT 2006 | ppminc
We stock all Quad oven parts, offer free phone support & we do field service work & training. Give us a call at: 603-895-5112 Precision Placement Machines Fremont, NH 03044
Electronics Forum | Tue Dec 02 18:15:57 EST 2003 | Karl
Try Fritsch USA PO BOX 157, BOWMANSVILLE, PA 17507 1 717 445-4760 We use it all the time
Electronics Forum | Wed Dec 10 18:47:28 EST 2003 | Rob Sierra
Hi James, Mag-D Electronics in Los Angeles ALSO carries ALL Tape Splicer tools and tapes. You can reach Mag-D Electronics at 818-762-0058 or http://www.magdelectronics.com. We also carry Adhesive Back Die Carrier Tapes and Feeders.
Electronics Forum | Mon Dec 08 09:10:02 EST 2003 | russ
Dean, thanks again. I am going to but a standard cable and see if it works. If not I will ask for your help. I don't know if this is a 1 or 2 All I can find is "Large" for the model. thanks again Russ
Electronics Forum | Wed Dec 10 17:08:56 EST 2003 | samaniegocesar
Hello to all I need your help and support, can somebody tell me wich is the best angle for the squegge to apply solder paste 45 degrees or 60 degrees. I will apreciate your soon answer.. Regards..
Electronics Forum | Tue Dec 16 06:21:01 EST 2003 | Kev
We run with various fine pitch and BGA technologies here and use a standard 45 deg angle of squeegee blade for all. No problems found. Kev
Electronics Forum | Sun Dec 28 09:36:15 EST 2003 | davef
Paul: You are correct, but: * No all Kapton tape suppliers provide equal quality product. [We have a buying list for Kapon tape supply.] * Applying Kapton tape properly requires technique and attention to detail.
Electronics Forum | Fri Dec 26 12:02:37 EST 2003 | irun
hi all we are in the face of purchasing stencil printer and we are looking for off-line with vision model. We are interested in MPM stencil Ultraprint 100 and SPM. My question is about your experience with Ultraprint 100 and SPM? Which is better, mo
Electronics Forum | Mon Jan 05 15:14:26 EST 2004 | Debbie A.
Hi JG, You can contact the factory at 310-618-8427 and asked to speak with the service department. We support all of our machines regardless of ownership.