Electronics Forum | Wed Mar 09 13:07:34 EST 2005 | jdumont
Good day all,we recently got our new xray system up and running and I am wondering if we need to report to the state,Rhode Island, that we have this onsite...anyone have any clues? The salesmen said we do not but id like a second opinion. Thanks JD
Electronics Forum | Thu Mar 10 04:12:01 EST 2005 | aj
Guys, I have a Dek Mk1-similiar to 265. I am having some intermittent problems with the Camera. The signal gets all fuzzy every now and again, by me disconnecting the power and reconnecting it works fine again . They are quite expensive to replace
Electronics Forum | Thu Mar 10 10:06:08 EST 2005 | steve
OK all you Gurus here's one for ya. Customer is tinning wires with standard eutectic solder in a solder pot. There is a blue tint to the solder in the pot. After tinning with OA flux, which I will change to NC shortly, he has clear teflon insulation
Electronics Forum | Thu Mar 10 15:43:06 EST 2005 | steve
Thank you both for your assistance. I knew that I could count on you folks. The customer has purchased No-Clean flux and is using it as we speak. Hows that for customer service.... All in a days work... Thanks again You make me look good!!! Steve
Electronics Forum | Fri Mar 11 14:04:34 EST 2005 | Micheal
I changed both cables and still the same thing. I have not changed the quad align cable yet. Any other ideas. Also when I do a run pickup 1 it works normal but when I am in run mode forget it, the z-rod now dont even go all the way down.
Electronics Forum | Mon Mar 14 10:38:02 EST 2005 | ???
Are you absolutely sure that you changed the x-y ribbon cables....the z is controlled through those cables and almost all the time one of the cables has an intermittent open. I think there is a small card in the top of the machine (under the black co
Electronics Forum | Sat Mar 12 23:50:47 EST 2005 | fastek
Marcus- I guess I'm too old school. When I was involved in manufacturing there wasn't any AOI and we got along fine for years without it, (like everyone else). But I can certainly see the benefits of it if you have highly complex boards that are jus
Electronics Forum | Fri Mar 11 11:10:59 EST 2005 | AshleyN
We are currently masking and dipping. I need to source a selective conformal coating machine. I'm looking for something that's easy to program, accurate, good running costs and all that good stuff, semi-automatic, and repeatable for operators to use
Electronics Forum | Tue Mar 22 03:23:10 EST 2005 | EA
Hi, We are trying to break a component ( SMT component ) off the printed circuit board and measure the quality of the solder joint. But, after breaking off and having the reading, we do not know whether the reading is it within the component specifi
Electronics Forum | Wed Apr 06 09:16:31 EDT 2005 | blueflag
Ive just checked all the cables that i can see and there seems to be nothing wrong. Have just put a brand new fuse in to mot z card and it has blown it. machine boots up, initiate the hardware and everything goes ok until it does the z height then i