Electronics Forum | Wed Sep 11 10:26:30 EDT 2019 | slthomas
It all depends on the method for securing the leads for cutting and whether or not the body overhang interferes with it. Is the lead span .300", .400", or .600"? Either way I'd call Hepco and ask....the worst thing that can happen is that you still
Electronics Forum | Mon Sep 30 09:40:57 EDT 2019 | proceng1
One thought. Since this machine uses the camera as the board sensor, I've had a metal board support right where the camera sets up to detect the incoming board. Try loading the board after removing all the board supports. If it loads, then try som
Electronics Forum | Wed Dec 23 12:53:59 EST 2020 | ttheis
Thanks for the detailed information. I have a spare dc/dc converter on order to try swapping them. Another note is all dc power is cut out by the pdp.ps1, not just 12vdc. 24vac power remains.
Electronics Forum | Wed Oct 02 18:26:49 EDT 2019 | tey422
First of all, General Vision for Juki is not easy to learn/understand, it would be the last option if other centering method fails; only advance Juki package programmer would want to play with General Vision. If possible, using laser recognition woul
Electronics Forum | Mon Oct 14 12:56:27 EDT 2019 | robl
Thanks. The key things for me are decent text recognition (not just checking pixel patterns), and very good component models to speed up programming and debug. We can run multiple board types per hour through ours. Also be nice if there was a dece
Electronics Forum | Fri Nov 15 22:05:09 EST 2019 | alanyang
Flexible circuits assembly is different from rigid board assembly. For some manfacturers, fpc assembly are some things more painful because the assembly quality is unstable. Recommend to check and hope these 2 blogs are helpful. Flexible Circuit Asse
Electronics Forum | Fri Oct 18 14:35:13 EDT 2019 | tey422
If all other tools appear to be working fine, only the A12 is having the issue. You might have a faulty tool(not within original spec). As Bruce suggested, check the A12 tool itself to see anything abnormal. If it's brand new, you might need some lub
Electronics Forum | Tue Nov 03 20:28:33 EST 2020 | williamrobbins
Yes, it is most likely the BIOS and Windows Time configuration. If you are familiar with how to switch to Windows Operating system mode and back it can be checked. Our displayed times are off but in ASM trace service the times are all accurate so I d
Electronics Forum | Tue Oct 22 21:24:02 EDT 2019 | richgreen01
Hi All I have the above machine and every day on start up i get the failed to initiate hardware message.I have been getting around this by re initiating the motor controllers and it is good to go after this.Does anyone know the causes of the initiat
Electronics Forum | Thu Aug 27 14:32:34 EDT 2020 | dekhead
Following a pressure error, if continue is pressed, the next print with THE CORRESPONDING squeegee should attempt to compensate by increase or decrease in pressure (as appropriate)... Is it: 1)Not changing at all? 2)Over compensating? 3)Under compens