Electronics Forum | Fri Sep 23 23:21:53 EDT 2005 | Mats
Please explain Your line configuration needs or the volume by: components/panel/day/operators(people)/investments/yield/customer requirements/Your own req./etc. that You need. In Your initial thread You said that You had a low volyme production and
Electronics Forum | Mon Sep 26 10:06:06 EDT 2005 | stepheniii
Make sure the stencil lined up perfectly in the middle all along the width of the board. Everytime someone has told me that a stencil doesn't match the board, they were not critical enough on alignment. Usually they would say one corner is perfect b
Electronics Forum | Wed Sep 28 10:27:08 EDT 2005 | SuMoTe
Thanks to Stevezeva for hosting the pictures: Bakers Secret pans are the way to go, I use the "bread loaf" size. http://www.stevezeva.homestead.com/files/DrainingSolderPot.jpg http://www.stevezeva.homestead.com/files/DrainingSolderPot2.jpg Pray t
Electronics Forum | Thu Sep 29 03:40:43 EDT 2005 | aj
I have over 6 years experience working on Dek Printers, and I would highly recommend them to anyone BUT I have never seen the 2D Inspection last any longer than a couple of weeks running on the machine. This is the one side of things that they FAIL.
Electronics Forum | Wed Oct 05 15:03:40 EDT 2005 | Amol
depends on what you want evaluated! you can thermal cycle the BGAs and the examine the x-sections to determine failure modes at different stages of thermal cycles. you can do a stress test and corelate the # of thermal cycles with the microstructu
Electronics Forum | Tue Oct 11 13:50:21 EDT 2005 | stepheniii
you take the stencil which is contaminated with basically a toxic substance, add a solvent (alcohol) then use compressed air to blast it all into the air you breathe. I used to use foam wipes that were pretty good. I've also seen thick clothe ones t
Electronics Forum | Mon Oct 10 08:53:54 EDT 2005 | rsmith@z-mar.com
The most important thing you can do is to maintain the same electrical potential between the ESD-S product, the operator and the worksurface. This is typically achieved through a grounded dissipative worksurface and an operator grounded via a wrist s
Electronics Forum | Fri Oct 14 15:44:30 EDT 2005 | fastek
Yes....interesting. Word is this better be successful for them or they are done. At first glance my issue would be what impact do solder paste "dots" have in the following areas compared to stenciled paste: 1) Controllable with regards to volume 2
Electronics Forum | Thu Oct 20 05:30:23 EDT 2005 | Slaine
Ive a 5 zone BTU vip 90 thats about 12 years old, and just lately its been a pain, its needed justabout all the fans replacing, the belt has eaten away the drive sprockets (they were fine a month ago) and just lately the belt speed has started to va
Electronics Forum | Mon Oct 17 16:11:14 EDT 2005 | saragorcos
Hello all, I am just trying to get the word out anywhere I can think of to encourage people in and around Indiana to come to the first meeting of the Indiana SMTA Chapter 10/20/05 at 6:30pm taking place in Kokomo, IN - email me if you're interested i