Electronics Forum | Tue Apr 05 14:42:41 EDT 2011 | clampron
Bigvern, We have had the same problem on two different occasions. Both issues were caused by the vacuum sensor. The first time this happened, we had a tech from Dage in to repair. This was fairly costly. When it happened again, we opened the cabinet
Electronics Forum | Thu Apr 07 04:32:13 EDT 2011 | jacki
Dear All During SMT process, some Tant caps were fell down without touching Epoxy . I found the problematic Tant Termanations were bended with gap. So I called to Vender and expalined this gap but the answer was the gap was within their standard and
Electronics Forum | Fri Apr 15 11:15:14 EDT 2011 | wrongway
Hello all lets see you are wanting to place 60,000 parts a day make sure you derate the machines you are looking at to about half of what they claim and your change over will take some time as well we do several change overs each day up to six tim
Electronics Forum | Mon Apr 18 10:07:19 EDT 2011 | wrongway
Hello Jebs we started out that way but the more handaling of the pcb the more problems you will have if you can do it in line and have the pcb's stop at some of the conveyors you can do some inspection. yes all of our machine's are in line now we lo
Electronics Forum | Mon Nov 21 18:39:55 EST 2011 | khid
i've been in manufacturing for 15 yrs. I used AOI with match patter as well algorithm base in one machine. Easy to program, can built in global library based on your cspecs or part number use in the manufacturing line. ROI can be achieved in the shor
Electronics Forum | Wed Apr 27 09:28:16 EDT 2011 | dittmann
Hi all, I would like to know, how can I check out, if this types of machines below, have GEM interface? Where and exactly how can I check it out on each of this machines? -Universal GSM2 4688A -Universal HSP 4796L -Hitachi GXH-3 -Hitachi GXH-1S -Hita
Electronics Forum | Thu May 12 18:32:02 EDT 2011 | jbaez1
Also... this is ONLY a pick issue? No issues with > placement for those that you do successfully > pick? > > Have the spindles been calibrated > lately? Hi Vickt! thanks for your comments,,during step mode no failure at all, the spindle moves d
Electronics Forum | Thu May 05 11:11:20 EDT 2011 | jimlas53
OK, understood. In the case of SO14, I have some in vibe feeders and some in tape. The tape parts, when I set the extent up, would be picked at 0 Theta, because the part length is parallel to the Y axis. The vibe parts, which are perpendicular to
Electronics Forum | Tue May 31 22:40:24 EDT 2011 | bejrananda
HI All, Please kindly advice me, I have project that it has DPAK part (MPN:SUD25N15-52 E3 Plating:100% Sn matte)which locate on bottom side (1st reflow), Good wetting for 1st reflow.. but .. when I run Top side (2nd reflow).I found that this D
Electronics Forum | Tue Jun 07 00:21:42 EDT 2011 | jacki
Hi All Currently, we encountered that the schottky barrier diode was up side down or misalignment during SMT process.And, many parts were blown away as pick up error. What we found is its package space is a little bigger for parts to move. I seek y