Electronics Forum | Wed Jan 11 10:12:23 EST 2006 | ratsalad
I've used an old version (maybe 7 or 8 years old) of GC-Place to convert gerber to centroid data. It is semi-automatic. If I remember correctly we'd start by selecting the pads for the largest components first. The software would find matching gro
Electronics Forum | Fri Apr 28 21:20:43 EDT 2006 | Baer
So what is your company? P. KAY is not aware of you or of this situation and we would like to discuss it. The only way that you could have what you claim is if the maintenance were not done and if spent MS2 were left on the solder pot for days. Like
Electronics Forum | Thu Mar 30 12:38:14 EST 2006 | Tech
Also why I am at it. In the book CP-6 Series Maintenance Manul ( Fuji Part # MNT-C060-11.3E ) in Chapter 4 page 4-1-11 it says " The clutches should therfore be cleaned regularly, using the grease cleaner (ThreeBond 2706) provided with the machine."
Electronics Forum | Wed Feb 08 04:08:35 EST 2006 | fctassembly
Hello Greg, I agree with you that the article in SMT Magazine should be studied very carefully as it contains many errors in respect to SN100C. The testing performed was a DOE and was not an optimized run. There is also a statement on dross generatio
Electronics Forum | Wed Feb 01 13:46:05 EST 2006 | Chunks
Sounds like a epididymis! It depends on your paste chemistry. You can't just slap any old saponifier in there. Most water based cleaners evaporate the water and you have to remove the dried paste. It's a bit messy, maybe that's why your's is over
Electronics Forum | Thu Feb 02 20:48:07 EST 2006 | ____
I would like to start a new post regarding fuji > NXT machine. What do you think about the machine > as far as the servicing of the machine goes. I am > so used to the older machines such as : CP,IP, > and QP. Those machines at least give you som
Electronics Forum | Fri Feb 10 12:09:53 EST 2006 | cyber_wolf
Russ, We use a unit called a Datapaq surveyor to monitor our ovens. Its basically a unit that a data logger rides through the oven in. It has 3 thermal couples across the top and 3 across the bottom. It takes measurements the full width of the proces
Electronics Forum | Wed Feb 15 21:18:03 EST 2006 | Spilly McNugglets
It's cumbersome. Also if it catches a part partially after initial set-up, you'll get missprints. We had one and caused about 15% missprints. Once removed and hard pin in place, no missprints. Defeats vacuum board hold down too, from all of it's
Electronics Forum | Thu Feb 16 13:21:24 EST 2006 | Bill C
Hi Russ, Thanks for the reply. No this is 856, I sprayed some on boards just to try it out and noticed it dries very quickly also but if its soldered right away as would be the case in the machine, it's fine. I believe I tried some 857 and found th
Electronics Forum | Tue Feb 28 16:10:21 EST 2006 | cmiller
We were also using DBA classic and went to Intuitive about 4 months ago. I think it is a good system but it is also a huge difference from DBA. We picked it for a number of reasons but .NET was a major one. To some extent we are still learning it so
.gif)
