Electronics Forum | Thu Aug 04 17:42:45 EDT 2005 | Neel
Rob is right on with the comments above. As I believe it is pointed out, check out Mydata and also Assembleon. In fact, in helping others like you I have found Assembleon to strike the better deal even over Mydata. You can teach parts and boards wit
Electronics Forum | Wed Aug 10 03:17:41 EDT 2005 | vinitverma
Neel's right! Assembleon Topaz is a very versatile machine for placing components from 0402 upto 32mm square. Moreover Assembleon also sells pre-owned but fully refurbed equipment and you could find a Topaz there too! Since this is not a sales forum,
Electronics Forum | Thu Jul 14 19:12:40 EDT 2005 | sync40
Hi. In the past years I had made dozens of PCBs but now I am trying to get a professional finishing on them. The main problem is oxidation of the copper traces. Basically I use the silkscreen method to make the pattern in both layers and then etch. L
Electronics Forum | Tue Jul 19 12:18:43 EDT 2005 | russ
We have had this problem with one of our machine although it is not a Mydata. We had to reduce the blow off time for these. Our problem was also these same Rnet packages. the part is proabably picked a little off center, then the blow off hits the
Electronics Forum | Sat Jul 16 16:21:56 EDT 2005 | Mark
Should solder paste be placed back in the refrigirator after use? If so, is there a limit on how many times we may take it out and re-refrigirate it? After receiving solder paste, it is put away in the fridge. Then, removed a few hours before use
Electronics Forum | Thu Jul 21 02:54:10 EDT 2005 | Base
(... so hard to resist... Rob is probably going to kick my derriere for this post...) So was Assembleon... They first placed a very large QFP (think it was 208) and then placed a whole bunch of 01005's in between the leads. And to top it off they al
Electronics Forum | Tue Jul 26 11:02:30 EDT 2005 | dphilbrick
I have a single sided PCB that contains 4 RF connectors that will require conformal coating. Sounds easy, well the RF connector is .080 in diameter and stands a whole .050 in height. The sub-straight that the barrel sits on is about .020 thick. I don
Electronics Forum | Tue Jul 26 23:02:22 EDT 2005 | crishan
Hello, We currently have huge quality issues with our Inertec selective solder machine, the model we have does not pump solder, rather the solder bath is raised to the product. We have continuing issues with bridging and non wetting of joints. We a
Electronics Forum | Fri Jul 29 09:31:29 EDT 2005 | lupo
Hello, I am not familiar with Inertec but have some expirience with selective soldering process, My oppinion is that the wave and slective soldering are not the same game. In Selctive soldering process is very important the layout design. If use th
Electronics Forum | Tue Aug 02 22:44:42 EDT 2005 | crishan
Thanks for the comments everyone. I did not think of checking the nozzles material, I will check this out. GS, What is PBM, is this some sort of ironiser. Also to clarify, we believe the that the pocket size for the component is too big allowing th
