Electronics Forum | Wed Nov 02 13:24:09 EST 2005 | valuems
Hello Sorry we have not answered sooner, been gone. There is a height adjustment on the wiper. You will find a round nob under it, that is a height adjustment. I expect the wiper is not going all of the way up. And you can also control the speed
Electronics Forum | Tue Nov 15 10:19:27 EST 2005 | James
Can I dip the populated board in flux and achieve good results? Also how easy is it to clean the flux off the board afterwards if it is waterbased? Do you simply brush the board with a damp brush or spray some remover on the board? I also have this q
Electronics Forum | Thu Nov 24 21:19:40 EST 2005 | smartasp
Hi, We are also a hig mix low volum plant situated in Sri Lanka and just installed 2 Opals inline from Assembleon with the feeder exchange carts for faster change over. This machines can be upgraded to Topaz by just installing 4 more heads. So far
Electronics Forum | Wed Dec 14 06:58:29 EST 2005 | jdumont
We have a version of the SMT Tools scope. We use it hand held style with no stand (much easier). We also find that it is not used very often. XRay and a reliable process are more important to spend the time and money on. This is a good tool to have f
Electronics Forum | Thu Dec 15 04:26:20 EST 2005 | Rob
Hi Liza, We tend to see it on the larger plastic tape sizes & lower volume parts - such as smd connectors, fine pitch reeled IC's, BGA's etc. We don't tend to get it on high vol parts such as logic, 8 & 16bit micros, v-regs etc. Could this be du
Electronics Forum | Thu Dec 29 05:56:37 EST 2005 | bobpan
Dont quote me on this because its been a while but i believe thats a grounding issue on the quad-align card itself. The card is located in the rear right bottom of the machine. Try adding a ground wire to the cage that the card is mounted inside. Als
Electronics Forum | Wed May 03 22:33:57 EDT 2006 | ramerez
I am based in Nogales and I have also tried the MS2, I was told to immediately cancel my trials, It did reduced the build up of dross but the mess it made to the wave and the surrounding areas was very bad, Everything was coated black and the smell a
Electronics Forum | Tue Feb 07 13:01:52 EST 2006 | amol_kane
Hi, does anyone have any experience with common wave soldering defects using SAC305 alloy?.....i am finding a lot of what seem to be shrinkage cracks on the bottom side surface of the soldered components.....there is also a lot of directional cooling
Electronics Forum | Tue Apr 25 07:44:39 EDT 2006 | Holly
MikeL, I came across your post. We are also a small company looking at rework systems for BGA/QFN/CSP. .5mm worse case pitch. We had a PACE 1700 on trial and we found it clunky and unreliable. We also evaluated a PDR 410 system and found it better
Electronics Forum | Thu Mar 02 04:24:46 EST 2006 | walbone
Hi, We have recently purchased a Quad IVC 115 pick and place machine but are finding it difficult to place SOT23 and similar components. The Visual alignment system rejects the components. We have manually measured and also got the system to measure