Electronics Forum | Mon Jun 29 15:33:28 EDT 2020 | jmelson
WOW, thanks for the documents, this will REALLY help selection. It looks like I want the FLX2011CV, that makes it a lot easier to set up and not have to reach into the machine to load and unload boards. The machine footprint is really compact, 10 m
Electronics Forum | Mon Jun 29 16:03:24 EDT 2020 | spoiltforchoice
I certainly can on the Paraquda and I suspect the basic algorithms are the same. Slimmer annular rings such as you might get on a plated via hole don't always image quite as well but if for some reason it doesn't pick it up you should be able to inte
Electronics Forum | Tue Jul 21 14:44:42 EDT 2020 | mcbasol
Dear Evtimov, Thank you for reply. We have decided to buy MS-11 3D due to competitive price and technical service in Turkey. Also, the technical information is quite good. Another reason that we eill buy Panasonic SPG2 Printer, too. Panasonic is solu
Electronics Forum | Fri Aug 07 13:30:22 EDT 2020 | emeto
ASM machines have great algorithms for BGA and I am positive it will detect missing ball. Still, on your pictures it seems like you are severely starving solder in the locations shown on X-ray. Part seem too small to bend that much in reflow to form
Electronics Forum | Wed Aug 12 17:57:32 EDT 2020 | glasscake
Due Diligence Post: Figured out my issue with the laser itself, it was set up in RS422 mode and it should have been setup in 0-10v analog out. As far as actually using the tools i have not got that far yet but I will DD again when I get that far. I
Electronics Forum | Tue Aug 25 20:06:12 EDT 2020 | ldavis
Yes, this consumption rate is normal for a high purity N2 process. We switched to a generator and had a payback of about 7 months. The bigger improvement than cost reduction though was in process consistency. When we were switching bottles we were
Electronics Forum | Fri Aug 28 17:24:28 EDT 2020 | stephendo
Did you check all the voltages and fuses? The second worst is when a machine is down for a while and it ends up being something basic. The worst is when it started as something basic and someone introduces a new problem. Also could there be any opti
Electronics Forum | Thu Sep 03 21:49:20 EDT 2020 | kylehunter
> Not in our case, the pre-heat temp was not high > enough. Also our pre-heat is only from top > (KISS104). Ahh that makes total sense. We have bottom IR, and have thermocoupled at 100c, so I think we should be good on that end. Anoth
Electronics Forum | Sun Sep 06 03:24:31 EDT 2020 | rsatmech
Hi All, We are frequently getting tombstone in an induction component. (0102) There is no paste offset or placement offset. PCB pad design is not as per recommendation. Stencil opening is 1:1 Same part used in two locations and both the locati
Electronics Forum | Tue Sep 22 22:15:05 EDT 2020 | stephendo
I seem to remember using a system similar to this one. http://production-solutions.com/redesetmanuallock.php The one I saw had the supports spring loaded and free when you first brought the support up to the board. Then you used an Allen key at the