Electronics Forum | Sat Dec 17 16:46:45 EST 2011 | eadthem
Startup current depends on your configuration. ours dose zones 1,2/ 3,4/ 5/ 6,7 last i checked it pulled about 40-55 ish on start up and 25-35 during run. our profile is a slow ramp till 170c then a fast ramp to 285c 280c(last 2 zones). 1707's
Electronics Forum | Tue Dec 13 17:41:04 EST 2011 | davef
A Study Of 0201’s And Tombstoning In Lead-Free Systems, Phase II Comparison Of Final Finishes And Solder Paste Formulations http://sheaengineering.com/Documents/APEX%2008%200201s%20and%20Tombstoning%20phase%202%20paper.pdf CONCLUSION The condition
Electronics Forum | Thu Jan 19 09:41:47 EST 2012 | charliedci
We have the same issues with QFN's on reels being cost prohibitive, so we also have to deal with tubes. We have had some luck with using a modified tube ran down (almost to the pick position) the channel of a belt feeder, assuming the QFN tube/channe
Electronics Forum | Mon Jan 16 00:47:47 EST 2012 | ngineer
I have two new quad feeder bases and feeders (my machine came with none to start, and I can't find any electrical information on them. I have 4 pins at the each end (total of 4 connectors. And are in a 4 pin connector which looks identical to a sta
Electronics Forum | Wed Feb 08 09:21:03 EST 2012 | ngineer
What Should I use to clean a sticking conveyor > belts in my pick an place machine (Quad IVc)? > The belts seem to have what I would guess to be > solder paste that is dried, but also they seem to > be a bit gunked up as if they had gotten some o
Electronics Forum | Thu Feb 16 14:02:28 EST 2012 | joeherz
We have been using a selective solder system for all of our automated LF through hole processing to this point. It has served us well but volumes are increasing and we are getting ready to pull the trigger on a full size wave machine to handle the l
Electronics Forum | Mon Mar 05 13:35:04 EST 2012 | acsscott
Figured out that you have to press Ctrl & Enter to get this screen to come up. Also, to remove the LCS, you need to remove the "Y" cable to the left of the control box in the bottom of the Topaz X. All works well now, but still can't get it to load
Electronics Forum | Tue Mar 06 08:00:30 EST 2012 | acsscott
Thanks for your input. I heard about the component size from someone else as well. They said if the component is greater than 8.4mm, it will not load another component next to it on an adjacent head, which is only 16mm away. The PLCC6 LED's are 5
Electronics Forum | Thu Mar 29 09:47:12 EDT 2012 | blnorman
In a previous life we burned bar-codes on PCB with a CO2 laser. Initially we placed a small white epoxy pad to burn the code into. After some experimentation we found that we could eliminate the epoxy and just burn through the soldermask and the un
Electronics Forum | Wed Apr 04 13:33:12 EDT 2012 | rway
We currently have 2 M1 systems. Our false call rate has never been has high as you suggest. There is something wrong with your program and/or inspection algorithms, as you probably already know. You should be somewhere between 1000-1500 vcpmo (fal