Electronics Forum | Mon Sep 12 03:38:03 EDT 2016 | rob
Hi John, We picked up a used laser marker (Asys ALS03) last year for around 30K euros and it has done approx 2M codes (we use 6mm square QR) in the last year without fault - it reads them all back to confirm which is handy. We also use labels, and
Electronics Forum | Fri Oct 28 13:58:57 EDT 2016 | ttheis
Hi everyone, We just picked up an old VIP70 oven and it is in need of more maintenance than we were told when we bought it so I'm working on a few issues. The main thing right now is linking the FCU controller to the PC. I've tried using both seria
Electronics Forum | Tue Nov 01 11:57:19 EDT 2016 | spoiltforchoice
I don't know how accurate an idea you will get on eBay. Here in the UK the only stuff that ends up on eBay is total crap, manufacturers and brokers between them seem to get hold of most of the machines when they come to the end of their lease or usef
Electronics Forum | Thu Dec 08 12:39:39 EST 2016 | deanm
We have a name brand aqueous batch cleaner that uses a chemical and DI water to clean ROL0 flux from our PCBs. It does ok most of the time for SMT boards and we want to include through hole assemblies as well which should be a better cleaning process
Electronics Forum | Tue Dec 27 09:39:36 EST 2016 | westshoredesign
Thank you for the reply, MPMEng. I received the Speedline UPG-026/27, but it actually came with the incorrect mouse. Since original post I've contacted seller, received correct mouse, successfully installed drivers, encountered a new issue. At thi
Electronics Forum | Fri Dec 16 13:37:52 EST 2016 | edhare
Hi all, > > Recently, we are trying to do > wire bonding between a 75 * 75 um pad on a chip > and substrate with 150 um height difference, but > when completing wire bonding and the wire bonds > on pad and substrate, the pad will get out of
Electronics Forum | Thu Jan 05 12:33:30 EST 2017 | rgduval
If you haven't resolved this yet, I think you're going to want to go to either the part or the package (I'm not sure which one off hand), and make sure that the hydra heads/tools are selected for placement. You'll also want the vision set to the lin
Electronics Forum | Thu Dec 29 09:03:03 EST 2016 | sumote
I would cut a piece of cardboard to the same dimensions as your circuit card. Run that through the fluxer of your machine and pull it out before the pre-heater. Take a look at the cardboard and verify that flux has been sprayed on it. That board look
Electronics Forum | Tue Feb 14 01:00:47 EST 2017 | soldertraining
Soldering Bath - When we need to tin high-power contacts or a lot of wires, for example, in making harnesses, a regular soldering iron is either impossible to use due to the high thermal capacitance requirement, or takes way too long to perform the t
Electronics Forum | Tue Feb 07 12:26:14 EST 2017 | westshoredesign
Oh yeah, so we have a auger valve similar to that on one of our other machines that we use for dispensing SMT glue, and solder paste also. We have a conditioner that we flush it with at EOD when in use, then we just let it sit idle with the condition