Electronics Forum | Fri Oct 03 08:58:22 EDT 2003 | SMT Process
Folks, I use both UP1500 and AccuFlex. The basis for this machine was bought from SMTech several years ago as the SMTech 500. They sold off the last few SMTech machines with the MPM name on them (stupid move because they sucked), but then quickly r
Electronics Forum | Mon Oct 06 08:51:26 EDT 2003 | davef
The EIA does not provide that information. EIA standards focus on component dimensions. Alternately consider: ...cut... SM-782A - Surface Mount Design & Land Pattern Standard, Inc. Am. 1 & 2 ANSI Approved Get up-to-date land pattern recommendat
Electronics Forum | Mon Oct 27 16:16:45 EST 2003 | Pat Fogarty
Good Morning John Your above enquiry has been brought to our attention by Mr Kenny Munroe of Permali Composites SA, France. Shamrock Industries Ltd are Tool & Die Makers, Precision Engineers & Original Equipment Manufacturers. We are based in Chri
Electronics Forum | Fri Nov 07 15:05:16 EST 2003 | stefwitt
It was not stolen, it was disposed Cookson profits from cost-cutting Electronics and ceramics group Cookson has taken heart from half-year results as all three of its divisions kept out of the red in the second quarter. The group says a recent co
Electronics Forum | Wed Dec 10 15:18:44 EST 2003 | Dustin
My name is Dustin Steedman. I have a Direct Hire position available in Michigan. I realize that you may be currently employed. However, I am sending you this email with the hope that you or someone that you know would be interested in this current op
Electronics Forum | Wed Dec 10 15:21:37 EST 2003 | Dustin
My name is Dustin Steedman. I have a Direct Hire position available in Michigan. I realize that you may be currently employed. However, I am sending you this email with the hope that you or someone that you know would be interested in this current op
Electronics Forum | Tue Dec 16 06:42:51 EST 2003 | Kev
I am having problems achieving correct pre-heater temperatures with our Hollis solder wave. Our original "Verification Golden board" program uses a conveyor speed of 5ft per minute and pre-heat temps of 300, 350, 400 respectively. Our "golden Board"
Electronics Forum | Thu Jan 08 16:43:43 EST 2004 | Dean
Unless your machine (internal) thermocouples are each calibrated and compensated no two machines will deliver eactly the same results. Here are your challenges: 1. Data acquisition equipment A-D converter errors 2. PCB measurement thermocouple (t
Electronics Forum | Tue Jan 13 16:01:06 EST 2004 | russ
I believe that solder paste will need to be applied to this part. I have re-balled these in the past in a low volume situation and here is what I did and there appears to be no adverse effects to the component. Get a stencil (I use 8 mil for .032"
Electronics Forum | Fri Jan 16 19:02:55 EST 2004 | Frank Gearhart - Assembl�on Snr. Software Technical Specialist
The OS/2 software you are referring to is the CSM-PPS v3 which was released in 1999, it is now out of service. The current software for optimizing, balancing, and generating programs for a Topaz and other Gem machines off-line, is GemLine-PPS v8.0,
