Electronics Forum | Thu Mar 22 12:46:43 EDT 2007 | Hussman
Those Panasonic machines should be able to tell ya pick-up rates form the feeders and shape code errors (components it doesn't recognize). You will probably get a more pick-up errors than anything else. Most of this is due to plastic tape versus pa
Electronics Forum | Wed Mar 21 17:47:05 EDT 2007 | darby
You need to use the H nozzle and 4 small jaws (1005). Have the slot in the jaws machined towards the rear of the jaw to increase reach. Set up and calibrate that head with that chucking assembly. Always use the same chucking assembly on the same he
Electronics Forum | Fri Mar 23 23:26:40 EDT 2007 | mika
Hi, We are facing a complete new package type for us in our prototype production. RoHS LGA 36 Land Grid Array with 36 so called pads instead of bumps underneath. It is totatlly flat. This component is only 6.5 x 3.5 x 1.6 mm and we recieved them in a
Electronics Forum | Sat Mar 24 12:31:31 EDT 2007 | diesel_1t
Hi there. Ok, i have a little big question for fuji Erudites: when machine run out of parts on any device it tells to machine "parts out (and part number)" So, a signal from anywhere (maybe a PLC output) will tell to the machine "hey i'm out of parts
Electronics Forum | Sat Mar 24 12:30:20 EDT 2007 | John B.
We're currently running a manncorp ECM-93, which has served us alright, but we've pretty much outgrown it. We manufacture power electronics, a lot of double sided designs with odd form parts. We have about 30 different designs we manufacture, and we
Electronics Forum | Mon Mar 26 14:35:44 EDT 2007 | ianchan
Hi all, First off, its great to be back on SMTnet after a long absence; wishing everyone the best in the year 2007 ahead. Question: Is there some sort of industry Standard (Mil?, ANSI?, ISO?) on the Calibration Intervals for mechanical based measu
Electronics Forum | Tue Mar 27 16:22:10 EDT 2007 | donjohnson
60G are common, as are vibration events of >1.5Grms. And drop heights are just outrageous, old billy throwing your new server off the truck doesn't care too much about the glass house theory, but loves to throw anything that he can lift... say he cra
Electronics Forum | Wed Mar 28 09:32:27 EDT 2007 | realchunks
Solder iron robots tend to miss solder joints from time to time. The wire feeder systems are the key to these machines. Most use the edge of the board for alignment is another reason they miss. If you have SMD close to the thru-hole, the robot may
Electronics Forum | Sun Apr 15 20:58:17 EDT 2007 | darby
PCB > Origin > O* > Skip = No Data In > PCB > Mount > M* > Skip = No Data In > System > Parameter > Position > Waiting Pnt Check that the waiting point is not set at such a co-ordinate that the PCB sensor is seeing the gantry. The pcb sensor also h
Electronics Forum | Tue Apr 17 14:57:10 EDT 2007 | ratsalad
Hi there CK, I didn't follow the link yet, but I thought I'd comment on your post here. I've attended two engineering schools in the USA, and one of them was a pretty darn good school. At both, I would have to say about 80%+ of the graduate studen