Electronics Forum | Wed Mar 03 05:07:06 EST 2004 | Javi
Hello, I would like to design the thermal reliefs/pads of my through-hole components. I would appreciate any info, doc or link about how design them (dimensions, slit width, circular or square, etc). Thanks a lot and best regards, Javi
Electronics Forum | Wed Mar 03 07:08:44 EST 2004 | jpa
Does anyone have an opinion, good or bad, regarding the mpm ap24x? I've only ever done manual printing and have little clue about automated printers. I'm pretty new to this whole arena and any suggestions would be much appreciated.
Electronics Forum | Wed Mar 03 07:26:16 EST 2004 | pjc
AP24X is old model. Some parts are getting hard to come by. Check if the vision system is Cognex 2000 or 5000 and what the computer is. It may have been upgraded. Otherwise, its a good printer.
Electronics Forum | Thu Mar 04 10:20:30 EST 2004 | Ken
If an OEM and room is available on the PCB....have pin location aids silk screened on the boards. Groups of 10 are typical. might look like 1.........10.........20.........30 continue this around the device. Otherwise, ???
Electronics Forum | Thu Mar 04 19:03:48 EST 2004 | pdeuel
Have you been re lubing chain after cleaning. Is the chain worn thru from friction on rails. How are carbonized particles removed from inside links after cleaning. What is recomended method for cleaning.
Electronics Forum | Fri Mar 05 06:27:11 EST 2004 | cyber_wolf
That hand held cleaner is 10K+. I have used one before. It works OK on paste, but doesn't do a thing for epoxy. 10 grand buys a lot of wipes and elbow grease.
Electronics Forum | Fri Mar 05 06:59:31 EST 2004 | t_white
We use a SAWA to clean our stencils and it performs quite well on solder paste but not so great with epoxy. Operators find the machine very easy to use and like mentioned before it takes up minimal space and has a lower intial and operating cost.
Electronics Forum | Mon Mar 08 08:28:32 EST 2004 | pjc
New Stencil Cleaning machine on the scene. Saw it at APEX 04, manufactured in West Viginia. http://www.pressureproducts.com/SPPC_Hm.htm
Electronics Forum | Mon Mar 08 15:47:04 EST 2004 | pdeuel
We had problems with paste drying out when opened for more than a couple of days. We solved this problem by ordering paste in 250 gram quanities. This is about a third of a jar in the same size container.
Electronics Forum | Wed Mar 10 08:33:36 EST 2004 | Gabriele
Take look also at IPC-HDBK-001, if not yet done, you can find helpful flux informations. Rgards GLS
