Electronics Forum | Mon Jun 19 21:40:52 EDT 2006 | davef
While underfilling BGA "mounted" on blacked pad boards could improve the reliability by attaching the BGA to the board, you should believe that all components soldered to the board will be affected by the black pad, not only BGA.
Electronics Forum | Tue Jun 13 14:16:56 EDT 2006 | adlsmt
Is anyone aware of any standard for bare board laminate for lead free assembly? We have been using IS410 with good results but not sure if maybe it is overkill and not worth the price premium? What is everyone else using?
Electronics Forum | Tue Jun 13 16:11:06 EDT 2006 | teamcanada
Anyone know of a clean effective way to remove silkscreening from SMT components? We are currently using a laser source removal process and wish to consider alternatives.
Electronics Forum | Tue Jun 13 19:58:33 EDT 2006 | davef
Team Services: Removing IC markings * methylene chloride to remove the markings * xylene and toulene will also remove some paints * "Black boxing" Simply use a tiny piece of sandpaper to "scratch the surface" and render the device blank. Chris: Sand
Electronics Forum | Wed Jun 14 08:33:30 EDT 2006 | davef
You're not that late. Every time we've been involved in part marking removal, it was done to make it difficult to pirate a board design.
Electronics Forum | Wed Jun 14 12:15:34 EDT 2006 | teamcanada
Dave F was right on the application, it has worked so far (3 years). Thanks for the ideas so far.
Electronics Forum | Tue Jun 13 16:33:26 EDT 2006 | markk
Anybody doing their own BGA Reballing? I'm looking for a good kit that can handle both leaded and lead-free. Any suggestions?
Electronics Forum | Thu Jun 15 22:03:32 EDT 2006 | Frank
You are correct, the Hover Davis label feeder works on 'un-punched' flat carrier. Get a sample of your dots on the tape and send it to Hover Davis to see if their feeder will work for you. The Hover Davis feeder will peel the dot off of the tape so
Electronics Forum | Wed Jun 21 16:09:14 EDT 2006 | adlsmt
Yep, we either use kapton tape or mask now depending on the application. It would be nice to be able to do it on a machine but the Hover-Davis label feeders are very expensive. May not be worth the cost for the volumes we run.
Electronics Forum | Thu Jun 22 13:55:56 EDT 2006 | grantp
Hi, Cool, and that would be a fantastic idea to do it in the SMT phase with a machine, and much faster. Your right about the feeder costs, and I guess you might be able to pick up something second hand? Regards, Grant