Electronics Forum | Tue May 29 11:59:53 EDT 2007 | leemeyer
Thanks for the info. I have installed Dos 6.22 and re-installed the SPM software. Now when I boot up I get an "invalid installation" error and the program terminates. Are there other setup issues I need to take care of.
Electronics Forum | Tue May 29 15:52:27 EDT 2007 | ck_the_flip
CURSE BILL GATES! Your next move should be to perhaps reformat the entire hard drive, re-install the software, and THEN try again.
Electronics Forum | Thu May 24 16:59:49 EDT 2007 | pjc
Is wash temp the same in the new washer? I'm thinking that may be a clue. Are you sure nothing else changed, like water supply at all- conditioner? Do you have a supply of DI water?
Electronics Forum | Thu May 24 17:11:22 EDT 2007 | colormaker
Everthing is the same. I did not check water temp or wash cycle time. No DI just straight from water supply. How do I do the DI ? Jerry
Electronics Forum | Thu May 24 23:07:55 EDT 2007 | colormaker
Our filter removes all contaminates authou it takes forever to evaporate 20 gallons it work quite well. I will check with local water supply for mineral analysis. Will a water softener remove the minerals that may be causing the problem ?
Electronics Forum | Fri May 25 13:32:26 EDT 2007 | colormaker
We have 4 diffrent boards that have the problem. The boards have two diffrent suppliers. I dont think this is the case. I more leaning toward not enough rinse cycles in the washer. Jerry
Electronics Forum | Fri May 25 03:28:20 EDT 2007 | shparekh
Hi All, Brand new here. I am wondering if I can find a breakout board for 0.4mm pitch SMD connectors. TIA. -sanjay
Electronics Forum | Fri May 25 08:11:22 EDT 2007 | davef
Welcome. Look here: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=28950
Electronics Forum | Sat May 26 02:50:15 EDT 2007 | bryanhanton
Hi. Currently we are in the market for UIC 4684A TAB Bonder. If anyone would like to sell such equipment, or knows where a machine or machines are located, please leave details. Best Regards Bryan Hanton
Electronics Forum | Mon May 28 08:17:25 EDT 2007 | aj
Placement is fine... There are other fine pitch components on the board which are fine. It is a 2up panel - one will be fine and the other might be shifted. Alternates between boards. aj...