Electronics Forum | Fri Jul 24 16:37:47 EDT 2015 | cnotebaert
to my knowledge it will always be manual insertion,, if you mean reflow, not insertion, I always apply solder to one side, reflow, then apply tacky flux pre print to the already soldered pins, print op side, assemble part then send through placement
Electronics Forum | Thu Jul 02 08:27:46 EDT 2015 | sssvajunas
Maybe someone know where company can buy MYDATA FLEX 24mm feeders(only used)? Becouse I found only Flex magazines, 32mm, 44mm feeders but not 24mm.
Electronics Forum | Thu Jul 02 09:30:28 EDT 2015 | mrsamiemiller
Good morning! You can try: Feeder Frenzy 131 Burke Street Nashua NH 03060 USA (603) 594-4229 Voice (603) 594-0554 Fax FeederFrenzy.com I hope you have a wonderful day!
Electronics Forum | Sat Jul 04 03:00:21 EDT 2015 | padawanlinuxero
i dont work for them but i get a lot of stuff of MYDATA with them IBE SMT Equipment 318 Corporate Woods Drive Magnolia, Texas 77354 United States Toll Free: (800) 353-6942 Office: (281) 259-9660 Fax: (281) 259-886 cheers!!!
Electronics Forum | Mon Jul 06 18:00:16 EDT 2015 | jwqc
Does any one know how to calculate BGA height change after reflow oven? I guess the calculation will be based on the component size, weight, ball diameter and ball count of the BGA, but how to get the actual height?
Electronics Forum | Tue Jul 07 10:25:03 EDT 2015 | swag
Dial indicator on a post/base. You might need a fine point tip to get between adjascent components and the BGA. Or... if you're real fance schmancy you could use a CMM if you have one.
Electronics Forum | Tue Jul 07 09:43:07 EDT 2015 | protokos
Hi all. I can buy 2 Royonic 510 tables. Now im looking for a manual , how to programm them. can anyone help me with a copy of the manual or, give me an workinstruction how to programm them Tanks Wil.
Electronics Forum | Mon Jul 20 11:31:52 EDT 2015 | heatherc
Aegis software has a programming solution for offline programming of these machines. http://www.aiscorp.com
Electronics Forum | Wed Jul 08 10:13:48 EDT 2015 | goodting
Dear ladies/gentelmen: I have a GSM Advantis machine which is funny to know that the DL 8mm Green PrecisionPro feeder only feed in one direction. They can not go backward which I think it is unreasonable. Can anyone give me a suggestion??? Thanks
Electronics Forum | Thu Jul 09 15:17:48 EDT 2015 | goodting
Thanks for the inquiry. We used MCD (Motion Control Dia) tool to verify if that is caused by VRM board. No respond(I means the related axis was off) was detected. we swapped that board to other machine, the VRM card was good.... X axis was stopped, t