Electronics Forum | Wed Nov 27 00:20:40 EST 2002 | Geronimo
Hi Andrew, From the way i see this is that you are trying to break some Juki codes...right? Juki Programs are proprietary and please don't use this forum to gain info on how to break codes. Try contacting your local Juki supplier in NZ or Australia
Electronics Forum | Thu Nov 21 14:17:27 EST 2002 | MA/NY DDave
Hi I can't give you the answer for your question because I have too many questions and would have to know a lot more before I was comfortable giving any advice. I have done mass Baking of piles of PCB's as a needed evil when piles of boards were ex
Electronics Forum | Sat Apr 26 04:17:43 EDT 2003 | PANKAJ SHARMA
Please be advised that India has very competitive SMT contract manufacturers. We are leading PCB assy contract manufacturer in India having two DEK-FUJI lines and are catering to Telecom,IT Hardware and Instrumentation industry for their PCB assy an
Electronics Forum | Thu May 08 18:36:56 EDT 2003 | slthomas
discussion, but how did this year-old thread get drudged up again? Don't answer that...it's a rhetorical question that I already know the answer to. Sign me, Steve, who's frankly getting a little rankled at the prospect of starting another job se
Electronics Forum | Mon May 12 07:33:30 EDT 2003 | stefwitt
To my humble opinion it is more a political question than medical or SMT manufacturing. While the Flextronics and Solectrons consider re-locating their manufacturing into Polen, Hungary or Bulgaria, you may ask yourself, if you rather make a call wi
Electronics Forum | Tue Nov 19 15:08:45 EST 2002 | steve
Be careful, if you are using a water soluble chemistry then your pre-forms that are impregnated with flux may dry out prior to use. If your using a no-clean application then ther should be no worries. Aim solder out of Rhode Island is very good with
Electronics Forum | Thu Nov 21 15:09:29 EST 2002 | Bill Barthel
There have been a number of papers and articles on the subject as well as tutorials and workshops sponsored by SMTA, etc. I can send you a paper I presented in 1995 that may cover most of your questions. There are also many other resources that mig
Electronics Forum | Wed Nov 20 10:33:14 EST 2002 | dphilbrick
Adam Generally the answer is yes. But there are many considerations. First a couple of questions 1 what flux are you using 2 Do you have top side pre heat in your wave solder machine 3 what is your measured top side temp. 4 what is your dwell time
Electronics Forum | Wed Nov 20 15:30:14 EST 2002 | caldon
KEVIN- I lived in Philadelphia for 35+ Years and never heard of them. I can not even find a web site on them. I know most of the local companies and can not say I have heard of them. Also, I checked my SMTA list and they are not there. I would think
Electronics Forum | Wed Nov 20 16:30:43 EST 2002 | Gris
Hi Here is an recent article on compatibility of Sn/Pb paste with Sn/Bi component finish ? Can somebody who is intrested help with what the contents are ? Thanks http://www.denso.co.jp/DTR/vol6_no2/dissertation13.pdf