Electronics Forum | Thu May 31 15:00:33 EDT 2012 | jdumont
I use Trace Labs and certainly recommend them. I actually just had this test done last week. Adhesion test per ASTM-3359 Method B. We also use Humiseal 1B73, which is similar to the 1B31 you use. Is your soldermask "active" enough for this coat
Electronics Forum | Wed May 09 11:59:50 EDT 2012 | aemtexas
Our Panasonic KME Create CM95R-M pick and place machine was in storage for a long time and the system battery died, so now the static RAM is corrupted. We need to obtain a "key" floppy to reflash the static RAM. Thank you in advance for any advice an
Electronics Forum | Thu May 10 15:32:45 EDT 2012 | 14367
We are having a lot of tomb stoning with this no clean solder paste. It's limited to larger, complex boards, affecting 0603 ferrite beads, capacitors and SOT23s. It was suggested that paste removed from a stencil should not be put back in it's origin
Electronics Forum | Thu May 10 16:48:27 EDT 2012 | markyen
All Professional, I've a GSM 2 flex head (2 beams). Beam 1, spindle 1 and 2 is disable right now. Spindle is not changing nozzle right now. How hard is it to replace the spindle? Does it involve calibration, and can anyone provide me with instructio
Electronics Forum | Mon May 14 11:41:22 EDT 2012 | kmakiya
It's been a really long time since I worked on a GSM but we did have some spindle problems and it was the clutch that was not working properly. The head was removed from the machine and a special tool was needed to remove the clutch. A caibration was
Electronics Forum | Fri May 11 15:33:36 EDT 2012 | markhoch
I personally believe that you money is best spent on improving your process. An automated printer will help make your process more repeatable, thus easier to control. An AOI will not improve your quality, it will only make your defects easier to dete
Electronics Forum | Wed May 16 09:23:04 EDT 2012 | jeremymek
In my experience Both Dek and speeline machines are good used. personally I think speedline seem to hold up better when PMs have been ignored though. Also make sure you can get a third party board support system into it like a gridlock or Vacunest
Electronics Forum | Thu May 24 06:55:25 EDT 2012 | miulius13
Okay, that was weird :| I didn't see the forest because of trees! Anyway, that's a step forward though I saw that OrCAD exports in .txt file and not Excel, as I need. Any ways to work around? Again, please be patient with me if, again, I can't see it
Electronics Forum | Tue Dec 18 10:14:14 EST 2012 | moshesh
In those cases where we have a 3.2mm thick, 16-layer board with several GND layers, do we still need ground connection to each and every layer (with thermal relief) or, skip part of the ground patterns? Will it help soldeing rising. I can't reach mor
Electronics Forum | Wed Dec 19 11:12:05 EST 2012 | aj
have you considered intrusive reflow? I ran a product similar to what you are describing and the only way we could get sufficient holefill consistently was by this process.... there may be obvious reasons why you cant but worth a shot if you can- it