Electronics Forum | Tue Nov 28 11:58:58 EST 2017 | emeto
Hello all, I am about to design a panel and there are two connectors on the board that seem to be very close to the edge of the board. I am worried that they might interfere with the cutter blade. Can you tell me how close do you think a part should
Electronics Forum | Wed Nov 29 21:00:02 EST 2017 | truthseeker
Thx for following up. We have a small PCB in a defense application that has copper sulfide issues. We are using Ion chromotagraphy to track down varions ionic species including sulfates. Your post was a aha moment for me. We have a sample being analy
Electronics Forum | Sun Dec 17 22:23:46 EST 2017 | jmelson
Well, I fixed it. I had resisted taking the motor off because of the recalibrations that would be required. But, it got bad enough I had to. Under the microscope, I could see copper dust packed between the commutator segments. I removed that, and
Electronics Forum | Tue Dec 12 19:57:56 EST 2017 | myke03o
Hi Experts. We have an expired OSP pcb and we wanted to extend the shelp life. Is it possible to rework the PCB by removing the OSP coating, micro etching and re-applying OSP finish. Any advice if this can be done? Any solution for this OSP pcb e
Electronics Forum | Wed Dec 13 08:54:28 EST 2017 | raymccomb
We have a DEK 265 and we have fitted new belts to it after one split in use. when we set back up and run program A all is OK, when we go to run program B it has System Error. Servo Following Error - Fatal Error - Reinitialise machine. Does any one h
Electronics Forum | Thu Jan 04 11:07:59 EST 2018 | ilavu
Ray, Did you solve this problem? I am having same error on same model machine. My problem is, when camera axis moves to look at the first fiducial, camera hits to the cleaner and error comes up with rising table error, camera axis not home. Even log
Electronics Forum | Wed Dec 13 13:11:06 EST 2017 | barryg
HI all. Recently we have been experiencing some PCB defects and so far it appears on a particular pcb. Components in areas, and the areas appears to be random, have shifted, skewed components. Most of these components, it appears the solder has flowe
Electronics Forum | Thu Dec 14 14:29:53 EST 2017 | barryg
We did check for oven clearance thinking the same , but there is plenty clearance. We have however found that the problem was on several lots of PCBs. We ran a fresh lot and problem went away. There appears to be some kind of contamination on the PCb
Electronics Forum | Tue Dec 26 02:10:26 EST 2017 | alexeis
Hi, We have develop a solution, called ASD, to online analyze and detect of real problem on SMT production. If you want more information, you can send me an email: alexeis@proventustech.com. Also, you can read about us and our solution on the websit
Electronics Forum | Thu Jan 04 02:54:20 EST 2018 | buckcho
Hello, I have experienced the same problem. It is a problem with your PCB manufacturer. If the paste goes away from the pads it is most likely PCB problem. How long does it take to produce from top to bottom side? The longer it takes, the worst the p