Electronics Forum | Sun Aug 13 10:49:23 EDT 2023 | kirill
Usually, for big connectors like this, you can use a red smt glue under the connector with a dispenser. If its not possible, you can use the same red glue and put a small dot on the side of the connector after reflow, and heat it a bit with blower, 1
Electronics Forum | Sun Aug 13 22:31:58 EDT 2023 | cspasol
Hi! I have encountered this problem so many times. Here are the possible cause of your machine problem. 1. PCI board or PCI to motherboard cable. 2. VME memmory card. 3. VME board itself. 4. Power supply for VME board. Hope could help.
Electronics Forum | Mon Aug 14 12:06:18 EDT 2023 | calebcsmt
Please elaborate, as I have already tried to rule out printer setup. 0 contact of course, ive tried a multitude of pressures, separation speeds, cleaning frequency. Moreover, i use these settings for similar stencils and have absolutely no issue
Electronics Forum | Mon Aug 21 16:36:14 EDT 2023 | merliniass
Hi friend, so I can give you good advice on this. To ensure a balanced and enjoyable experience, it is imperative to set a budget for your gaming activities and adhere to it. While online slots may be an entertaining pastime, https://cityslots.org/bo
Electronics Forum | Tue Aug 22 15:22:46 EDT 2023 | thecolonel97
Our paste manufacturer failed to respond. I did try adding 2 frozen jugs of water into the reservoir tank, this did not lower the cooler 1 temp. We have to have a water or air flow restriction causing this to run hotter. Still currently investigat
Electronics Forum | Wed Aug 23 14:58:38 EDT 2023 | markhoch
I was at our local SMTA Michigan Chapter Tech Forum & Tabletop Expo last week and BTU was introducing a new option designed to reduce flux build-up in the heating zones. Might not be a bad idea to reach out to them to learn more about it. Just a sug
Electronics Forum | Thu Aug 31 14:15:34 EDT 2023 | compit
Hello What feeder do you use for the long connector (65-80mm) - tape feeder, tray? What nozzles? We want to mount a SODIMM200 socket. I don't know whether to look on the tape or on the trays... The MG1 spec says it will mount connectors up to 100mm (
Electronics Forum | Fri Sep 01 11:55:27 EDT 2023 | tommy_magyar
In my previous job we fitted these connectors with bespoke gripper nozzles (ASM/Siplace) from bespoke trays made for these due to the high volume. It also reduces the risk of damaging the component further in case of a reject. However, at my current
Electronics Forum | Fri Sep 22 08:22:17 EDT 2023 | linux
Hello All, This would be a question for someone with experience in PCB design, Intrusive reflow Narrow profile connector(Electrode Rectangular) L=1mm X W=0.9mm. What shape and size hole is required in the PCB to ensure sufficient solderability and re
Electronics Forum | Tue Sep 26 07:46:49 EDT 2023 | robertanderson
A transformer winding machine is a specialized piece of equipment used in the manufacturing of transformers. Transformers are electrical devices that transfer electrical energy between two or more circuits through electromagnetic induction. They cons