Electronics Forum | Mon Nov 27 12:22:52 EST 2000 | rabell
You might want to check with Atlas Copco re the characteristics of the tool case. Although it is plastic, it could have been formulated to be dissipative. Unfortunately, with power tools there is always the conflict between the need to isolate the
Electronics Forum | Mon Nov 27 11:22:37 EST 2000 | Dave F
Please benchmark training given by electronic board assembly companies according to: * Style (eg, classroom, OJT, off-site, etc) * Type (eg, job, safety, environmental, quality, etc) * Size of company (eg sales, GT $500M, LT $500M but GT $50M, LT $50
Electronics Forum | Thu Oct 26 18:10:11 EDT 2000 | ptvianc
Philip: Cases 1-3, those criteria may be specified in more recent versions of ANSI/J-STD-001 and/or ANSI/IPC-A-610. Unfortunately, I do not have any new versions of these specs. that may cover these points. As for voids in BGA joints, I have not
Electronics Forum | Thu Oct 26 16:38:08 EDT 2000 | Philip A. Reyes
Hi Sir Charles! Good Day! I hope you can help me about my queries. 1. What is the acceptable misregistration or misalignment of balls after reflow soldering of PBGA module on the PCB? 2. Is there any criteria for solder ball defect or solder beads
Electronics Forum | Thu Oct 26 09:26:32 EDT 2000 | ptvianc
The book is available through the American Welding Society as well as through the Surface Mount Technology Association bookstore. The contact information is listed below: American Welding Society 550 N.W. LeJeune Rd. Miami, Florida 33126 Phone: (80
Electronics Forum | Tue Sep 19 14:40:13 EDT 2000 | Erick Russell
It is always a good idea to heat the entire board to 100C to 140C prior to reflowing the site to be reworked to reduce warp and localized stress. (Thermal uniformity of the preheater is key here). For a BGA, the laser is programmed to heat only the
Electronics Forum | Wed Sep 20 09:02:24 EDT 2000 | Erick Russell
The programming is simple and is based on just a few simple parameters. There is no CAD interface required to program the equipment. You must key in the dimensions of the component (X-Y and Thickness) and then specify the required thermal process.
Electronics Forum | Tue Sep 19 09:34:33 EDT 2000 | Erick Russell
There are two places where Laser Soldering is used for rework. One is the low volume, high mix environment where the board value is high. The other is the high volume (regardless of mix) facility where fast process time and quick set-up is required.
Electronics Forum | Mon Sep 18 12:04:43 EDT 2000 | Erick Russell
Photonic Soldering is useful for several applications in rework where current methods using hot air are inadequate or inefficient. For high-density assemblies, component clearances are limited. In the past, DFM (Design for Manufacturing) specificati
Electronics Forum | Fri Sep 15 05:48:24 EDT 2000 | carsonho
Have any experience that Sn/Pb plated integrated circuit products will appear some rainbowbridge-like substance after exposing at conditions of 121degC, 100%RH and 15psi for 48hours or above? The rainbow bridge substance was analyzed by EDAX and fou
.gif)
