Electronics Forum | Thu May 15 15:02:03 EDT 2008 | ccross
We have seen this problem before. We have ALWAYS found it to be a board vendor issue. Also, we tend to see it more during the summer months. Our solution has been to bake our PCBs @ 50 deg C for 1 hr prior to use. We use immersion white tin board fin
Electronics Forum | Fri May 23 23:47:46 EDT 2008 | dint46
Wayne; Several things. 1.check the vendors and see what black oxide they are using are they the same ? It might be that. 2.You should bake your pcbs before the thermal stress is applied. To remove moisture. At your shop. The proce
Electronics Forum | Fri May 09 09:25:24 EDT 2008 | russ
Hi Dave, we have thought about it, but would like to have something that we can use anytime we want, The dosimiter badges are good except they have to be sent in and then we wait for results. we have people here that are afraid to even walk in front
Electronics Forum | Sat May 10 11:17:14 EDT 2008 | fishingfool
RDR, If you buy a meter you have to send it in once a year to get calibrated at a certified calibration lab. Can be expensive. If you use one that is not certified, and something happens your company will be legally responsible. Major risk. Go
Electronics Forum | Fri May 09 16:30:47 EDT 2008 | wrongway
we had a 1995 dek 260 in 2005 we bought a ekra X5 these two machines wre not alike at all but our ekra has been performing very well for us we run at least 2 shifts 5 days a week. have had to change couple of switches and tighten a belt and a new po
Electronics Forum | Fri May 16 03:37:04 EDT 2008 | ianlg
Hi There is a Benchtest on the EPP Stand at the SMT Hybrid & Packaging exhibition that may be on interest to you where 11 printers are going to be tested against each other. It should be interesting to all who are looking to purchase a screen printe
Electronics Forum | Sun Jun 01 00:58:09 EDT 2008 | robi
Just for INFO Folungwin Printer Win 6 simular to Ekra but with major design improvments, also in the next year a new printer to be released The Smart 3 which is simular to a Dek but with 39 design changes of improvement, both printers are same as be
Electronics Forum | Wed Jun 04 12:54:18 EDT 2008 | robi
Hi thanks for the reply Sorry its not 94th its 14th unit and its across Americas, We only started early last year as we had so much pressure to introduce another success like our reflow which i know your aware as we sold the most ovens globally. SM
Electronics Forum | Mon May 12 16:31:39 EDT 2008 | tsvetan
Hi, there are different BGA packages, it's not same to rework LFBGA with 0.5 mm step and BGA with 1.27 mm step for instance basically you will be able to de-solder the BGA with hot air and proper nozzle which distributes the heat even on the BGA pa
Electronics Forum | Tue May 13 08:57:19 EDT 2008 | locostpp
It will be rigid, but not as rigid as something weighing 600lb's. We can't afford to cast/machine parts for a low cost machine. But we think have found techniques that can calibrate out any small distortions in the unit. Your comment about a decen
