Electronics Forum | Mon Jul 14 10:42:47 EDT 2008 | ck_the_flip
Patrick...I'll give you a couple of examples. Wave Soldering, the Science: you're getting solder shorts and you slow your belt speed down just a bit knowing that this effectively lowers your contact length and improves your peel-back for that tou
Electronics Forum | Mon Jul 14 15:44:19 EDT 2008 | stepheniii
when you change one of previous mentioned > parameters. Contact length with the board should > never change when the conveyer speed is changed, > only contact time should change. If I understand correctly then if you change nothing else, dwell t
Electronics Forum | Tue Jul 15 08:01:37 EDT 2008 | amcross
Grayman, Respectfully, you are off base. Many US companies pay their best engineers FAR more than any managers other than their executive VPs. Exceptional tchnical skill, absent management ability, IS rewarded VERY highly here in the US. in the past
Electronics Forum | Fri Jul 18 09:19:27 EDT 2008 | amcross
Thank you, all, for the honest and open discussion with just a few small sidetracks. We have had several people apply which I believe became aware of the opening thanks to this post. I can't thank you all enough for that. We are still searching but
Electronics Forum | Wed Jul 02 00:53:47 EDT 2008 | tsarapin
Thanks for your post Deni. As far as I know, HP300 software written in HP BASIC, it communicates with SMT machine over HPIB. We can use PCIHPIB interface card and port software to x86. SMT software is over 5000 strings in HP BASIC, most of them is a
Electronics Forum | Tue Jul 01 17:15:03 EDT 2008 | ronhodgson
I would like an interpretation of a solder fillet on a 5 side termination cap. (Ref: IPC-610, sec. 8.2.2.6). My question pertains to the definition of dimension F, and what constitutes the top of the fillet. Does the top of the fillet end at where
Electronics Forum | Wed Jul 02 02:46:44 EDT 2008 | tang
Hi Guys, I have few question would like to ask regarding pcb conformal coating: 1. Can I know which masking material is the best for easy apply, fast cure, fast & easy to remove after coating & baking. And no chemical reaction which will whiten the
Electronics Forum | Wed Jul 02 20:39:13 EDT 2008 | mika
Check this out .http://help.sap.com/saphelp_di46c2/helpdata/EN/7f/a7e7434d6011d2b438006094b9c9be/content.htm That's one way how to do it. Or read this: http://www.waterloo-software.com/limitations.html We have no relationship or what so ever with
Electronics Forum | Thu Jul 03 08:53:27 EDT 2008 | rgduval
I would...and then use the data of the known issues as part of the secondary analysis. The defect is a defect, one way or the other. You can use the secondary analysis of your PPM numbers to continue to drill down in the process. If your overall P
Electronics Forum | Thu Feb 05 23:55:52 EST 2009 | sachu_70
Considering a lean management on your shopfloor, any amount of inspection being done to a board, either by QA or Production personnel, does not add value to your product but instead, adds to your operational cost. You can explore to possibility of ca