Electronics Forum | Tue Feb 01 10:34:13 EST 2011 | scotceltic
I am currently looking for a quicker more efficient way to kit our parts from pulling to the carousel to organizing feeder locations on our SMT equipment. Currently we pull our parts and place them on a rack in no particular order. (we have too many
Electronics Forum | Thu Mar 03 09:20:35 EST 2011 | scotceltic
Thank you for the responses. Since my post I have worked with our Bartector software developer to come up with a nice setup that will save us approximately 60% of our previous sorting time. Basically with a minimal setup of 5 minutes or so I can now
Electronics Forum | Fri Feb 04 16:24:00 EST 2011 | snigro
Rodrigo I am the service manager of Mirtec. When your using ATT It tries to match the saved image to what is on the board. If the area isnt a good match, it will not program the part. At the bottom of the ATT window, select the tab labeled 'mmd file
Electronics Forum | Fri Feb 04 16:55:29 EST 2011 | rodrigo
Thanks for the reply. I understand the second owner package is $6k plus travel fees. Is there another option for getting the newer software ... at a much lower price? Is the newer software that much better than the one we're using? A do-it-yourself k
Electronics Forum | Tue Feb 08 04:27:55 EST 2011 | thomas111
hi, I am a Hardware designer . One of my products is undergoing a Reliability test in which a resistor shows a high value on board from its specified value .However it retains the original value when its cooled under room temperature. The resistor
Electronics Forum | Wed Feb 16 12:47:58 EST 2011 | dennisfo
I've been here approx. 3 months. It was indicated that Xylene has alwas been used but it was never indicated that bubbles were not present in the past (ignored or touchup). I have a sample of Humiseal 73 thinner ordered for testing. We've been thinne
Electronics Forum | Tue Feb 08 19:24:30 EST 2011 | swag
We are going to buy a new reflow oven this spring. It will replace one that is currently on-line. I have a small handful of golden boards wired with thermocouples and a ton of data to support the transfer of those specific builds. The hurdle is th
Electronics Forum | Thu Feb 10 07:46:37 EST 2011 | sigmaprint
Hi, SigmaPrint is the authorised supplier for service and genuine spare parts for the complete range of SMTech equipment aquired by Speedline in 1999. Servicing and parts supply are handled by ex SMTech customer support engineers who have an extens
Electronics Forum | Thu Feb 10 19:54:28 EST 2011 | kahrpr
You answered your own question you get what you pay for. $3500 dollar’s for a small oven is not unreasonable. I have seen small proto type ovens do a pretty good job on basic circuits. If you are getting into high density BGa stuff and multi layered
Electronics Forum | Fri Feb 11 17:02:57 EST 2011 | gabriel1blue
Hello, I have a CSM-84 pick and place machine, and every time a make a programm the location where the part get place is way different from the location on the program which tell me that the offset's are way off, but when I try to calibrate the mach