Electronics Forum | Tue Jun 29 11:46:56 EDT 2021 | stephendo
It's been a while but what about the nozzle? Is it still springy? And did you check the part data? At one place our machine would be metric or imperial depending on a visitor from HQ. If you are smashing parts on the board that isn't good and if you
Electronics Forum | Wed Jun 30 20:32:44 EDT 2021 | rgduval
Check the friction numbers...there could be an issue with the z-wagon bearings, or something else adding tension to the z-travel. Also make sure there are no cables interfering with the z-travel. Could be a cable that moves into the way at some spe
Electronics Forum | Mon Jun 21 13:16:18 EDT 2021 | tomdegas
I just received the following messages while running our MY15: I-OSM-0: my15n150 kernel: lp: no devices found. I also received this one: I-OSM-0: my15n150 insmod: /lib/modules/2.2.20/misc/lp.o: init_module: Device or resource busy. And this one: I-
Electronics Forum | Tue Jun 29 15:16:55 EDT 2021 | pjchonis
Very cool to hear your thoughts! Definitely will have to post in here once you get enough experience with that HYDRON 220. I would love to hear more of your opinions. Honestly, we are a competitor to them and we want to make sure our products are th
Electronics Forum | Thu Jun 24 07:50:36 EDT 2021 | ouaret
we have a Cyberoptics Flex ultra HR machine (model N 8010949). the alignment of camera 1,3,5 and 2,4 is impossible because the images from each Fire wire adapter don't have the same size. we tried to calibrate with the target board, but also unsucce
Electronics Forum | Sat Jul 03 19:17:49 EDT 2021 | oriolsancheza
Hello, We recently purchased two Orbotech Vantage S22 without any manual/guide for setup. So it's being quite difficult to make them work. We tried to contact orbotech but no luck, nobody replies. One of the machines hangs when starting Orpro First
Electronics Forum | Thu Jul 08 16:15:12 EDT 2021 | stephendo
Just to be clear, you mean the card says that the moisture level is good but in reality the part has too much moisture? And you are not one of those people that vacuum seal MBBs with as much vacuum as possible are you? If you do more than lightly ev
Electronics Forum | Fri Jul 09 12:36:48 EDT 2021 | djenkins62
Great Question 1. Informal Testing with scales from Engineering Students at San Jose State. Report available upon request. 2. Internal Testing - Informal with scale 3. Visiting, Listening and Learning from SMTA Engineers...unfortunately, they wi
Electronics Forum | Tue Jul 13 16:29:25 EDT 2021 | stephendo
I didn't see that but I was thinking he could sprinkle it with holy water and repeat in a loud firm voice, "the power of Christ compels you". Or he could find an IT forum instead of a manufacturing one where our printers use a stencil and print bric
Electronics Forum | Thu Jul 15 15:57:39 EDT 2021 | kumarb
Here you go: https://we.tl/t-qQkEpE8H3p Suggest to also contact Trans-tec USA for any questions that you may have about this tool or any other. As an owner of the machine from Assembleon / Yamaha - they offer support. They have been great to suppo