Electronics Forum | Fri Jul 20 08:16:38 EDT 2007 | chrispy1963
I agree that it would be crazy to think that every part a company manufactured had to be re-engineered to allow for higher temps. Out of the question and I NEVER implied that at all. What I said was that Zarrow told us that it was alright to use lea
Electronics Forum | Mon Jul 23 11:06:43 EDT 2007 | gmoritz
Steve Thomas: Thank you for the well-written, helpful explanations. Fastek: You must be an accountant. Your advice was totally correct, but of absolutely no use whatsoever. Why even post it? I was basically told; Suprise! You are in charge of o
Electronics Forum | Thu Aug 09 15:54:12 EDT 2007 | jimmyjames
We have the same problem at times but our feeders tend to move to the back when we want them on the front. We have Opal machines but all the software should be the same. (assuming you have the offline programming/optimization software, AMS) What yo
Electronics Forum | Mon Aug 13 05:39:31 EDT 2007 | saaitk
I am building a double sided SMT board. On the first side I have a 405 ball BGA. When we build and run the second side through our reflow oven on about 25% of the boards run the 405 ball BGA on the underside of the board has fallen off. About 80% of
Electronics Forum | Tue Aug 28 10:21:41 EDT 2007 | gmoritz
I'm using a separate thread related to another thread because I didn't think it appropriate to 'pile on' to my tale of woe. This question is strickly operational: - . - . - . - . - . - . - . - . - . - . - . - . - . - In using a Universal Radial Inse
Electronics Forum | Mon Sep 24 07:38:01 EDT 2007 | chrispy1963
I never saw in any post if your machine uses the camera to find the board edge or if your machine uses the bottom front rail mounted board stop sensor. Also is this with only one particular job you run on this machine or is this happening with ALL
Electronics Forum | Sat Sep 22 02:14:08 EDT 2007 | mika
Another thing to make sure of and the vision calibration system will fail if this is out of range: Use a magnet foot stand micrometer and measure the spindle run outs. First remove the nozzles and nozzle adapters, then put the adjustable tip (I dont
Electronics Forum | Fri Oct 05 21:29:43 EDT 2007 | mika
Hussman, I don't understand the last sentence of yours "but far from where this thread was going". What do you mean with that? I was just trying to give "Novaman" some infos. The fine old equipment You use from the old -20:s or so, is probably just a
Electronics Forum | Tue Oct 02 10:08:20 EDT 2007 | allgood
Well apart from us being in the UK and I suspect you are over the pond, you wouldnt want to work with me for what I can pay! I am looking for a partner though......! We do punch above our weight already in that we must be Aegis's smallest customer
Electronics Forum | Thu Oct 11 14:56:27 EDT 2007 | chef
Thank you- my point exactly and it starts in SMT- operators pulling the wrong paste from the fridge, touch up using the wrong solder wire, etc. My solution- GET THE LEAD OUT!!!!! I'm a CM- high mix, low to medium volumes. No steady all day every day