Electronics Forum | Wed Apr 30 12:26:10 EDT 2008 | dphilbrick
There must be discussions about this on SMTnet but I have yet to find them. I would like to hear from all you smart people about running LF and PB BGA�s on the same board using 63/37 solder. If you run your profile up to peak at around 225C +/- (nitr
Electronics Forum | Wed May 07 14:19:58 EDT 2008 | adamcrum
Why not. He's an easy target, just look at him. Like a deer caught in the headlights. But what do you think about the other info? About the EPA. Did you know that when asked if we could inform other local companies of their policy, they told us no.
Electronics Forum | Thu May 08 12:28:37 EDT 2008 | adamcrum
The rep from the EPA told our director of operations that it can not be faught. Apparently he was really rude and basically said (with his team of over paid lawyers there of course) that the one company that tried to fight one of these fines ended up
Electronics Forum | Thu May 08 12:53:41 EDT 2008 | patrickbruneel
This sounds really fishy. But of course we only hear one side of the story. Again the EPA is not out there to fine companies UNLESS everything else fails. You say �The rep also very sternly informed us that we are NOT allowed to form any campaign th
Electronics Forum | Fri May 09 16:30:47 EDT 2008 | wrongway
we had a 1995 dek 260 in 2005 we bought a ekra X5 these two machines wre not alike at all but our ekra has been performing very well for us we run at least 2 shifts 5 days a week. have had to change couple of switches and tighten a belt and a new po
Electronics Forum | Tue May 13 08:57:19 EDT 2008 | locostpp
It will be rigid, but not as rigid as something weighing 600lb's. We can't afford to cast/machine parts for a low cost machine. But we think have found techniques that can calibrate out any small distortions in the unit. Your comment about a decen
Electronics Forum | Tue May 13 12:41:09 EDT 2008 | mmjm_1099
HELP ME !!!! Going crazy with this XP242 with a simple 5mmx5mm part. We have run this product in the past plenty of times and all of a sudden its placing it about 3 mm too high than it should be at. The rest of the parts on the board are placed perf
Electronics Forum | Thu May 15 09:51:49 EDT 2008 | cbroegger
I have bought an old SP-2400 screen printer, very cheap. I have "repaired" it from my best knowledge, replaced all pneumatic tubes that were in bad shape, replaced some logic in the "controller", and changed it from 110v operation to 220v. Well, to
Electronics Forum | Mon May 19 15:42:37 EDT 2008 | torch
hey folks, just finished a quick 4 day training course on our 2nd user Quad QSV-1 and will probably have more questions later on but for now can someone confirm that qsoft needs its theta data in + numbers and cannot handle - theta figures? what i m
Electronics Forum | Wed May 21 04:50:51 EDT 2008 | aj
Hi all, We had similar problems a while back. Boards would fail at test but if you applied pressure to the BGA they would pass. Turned out that during the PTH assembly process the Operators were flexing the cards during the insertion of an Oupin C