Electronics Forum | Thu Aug 24 12:53:56 EDT 2006 | russ
yes, it could have been from all 3 locations. without any detail whatsoever about your process or anythign it is impossible to help!! please check your incoming material prior to processing please check your reflow profile to ensure that max temp
Electronics Forum | Thu Oct 19 20:03:04 EDT 2006 | darby
I agree with Stephen there! Or maybe we just didn't care enough about looking into it in the COLD profile days! Back to df: I don't think any manufacturer is going to give you a tolerance level, they'll stick with what they've told you -225. If it's
Electronics Forum | Tue Feb 27 11:03:09 EST 2007 | Marcin
Hi All, Anybody knows what is the minimum clearance between through hole component and chip component? Problem description: On bottom side of my pcb are only 0603 chip components mounted on glue. One of the component is located very close to hole
Electronics Forum | Mon Apr 02 09:24:16 EDT 2007 | ed_faranda
I do this ALL the time, and it is pretty much transparent to the process. We have done shake, burn in, and functional tests with our products and we didn't have any issues what so ever. We have had a RoHS complient process for well over 18 months n
Electronics Forum | Sat Apr 28 17:35:21 EDT 2007 | grantp
Hi, I don't want to be impolite here, but I must say that it's really weird that because your based on Syria, so you "don't want a US made machine" however I think about 95% of the people on this forum and the forum itself are USA based, so it's ok
Electronics Forum | Wed Jul 18 03:55:39 EDT 2007 | allgood
Thank you for the reply - and yes its a TP9-UFP! Problem doesnt happen all the time and may not happen for extended periods on the job where we see it most - this particular job uses all feeder slots so the head is whizzing back and forth quite a l
Electronics Forum | Wed Sep 17 05:18:55 EDT 2008 | ralphspm
Our Fuji IP2 has a problem reading fiducial marks.It finds the mark(is shown on console display) but after time gives out the error statement "image display time over".It gives out an error status code of "FFFC" on the console display.Cannot find any
Electronics Forum | Tue Nov 25 11:58:31 EST 2008 | rway
Hello all, We are using z1850/60 machines. The APC test is damaging a 1.8V device on the board. The APC stimulates -/+3Vdc in fast mode. I understand the dangers of over-voltage. But what I need to know is how the part is being damaged when the ent
Electronics Forum | Sun Dec 14 09:27:29 EST 2008 | equipsolutions
I would recomend you a machine which neither requires big current ore airconsumption! Further all you should check sources of onsite support from vendor site, as I would recomend in many cases to order their service, then any second source supply! Fu
Electronics Forum | Mon Mar 30 15:16:32 EDT 2009 | Peter
Hi Tom, You're right. I do find the second locating pin hardware. Now I got them both up/down when F3 is pressed. Thanks. I don't see any pin on the hardware and no edge clamp hardware either :-( , do you know any way that I can bypass these hardware