Electronics Forum | Mon May 23 22:30:36 EDT 2005 | Frank
Hi all, I am trying to solve a problem with a CP643E any help on it please,It stop during production on an error for (Outside Target Position). Cheers Frank
Electronics Forum | Wed May 25 09:02:20 EDT 2005 | russ
Send your gerber data to the above mentioned or any other pallet Mfgr. If the assembly is designed with pallets in mind I am sure that one can be designed for your application.
Electronics Forum | Wed May 25 09:56:27 EDT 2005 | jdumont
What is everyone using to secure their caps on products that go through ESS testing. We have been using Dow 3140 RTV but it takes too long to dry and I read that RTV isnt the best anyhow. Any suggestions...
Electronics Forum | Wed May 25 11:51:27 EDT 2005 | jdumont
Yea that was my post from a while back. Never really got any good answers though. Let me know if anyone knows of anything. Thanks in advance... JD
Electronics Forum | Wed May 25 12:12:26 EDT 2005 | Dave G
3M jetmelt. A bit better than off the shelf reg hotmelt. Also use a GE white RTV. Never had any caps come off the board with either. DG
Electronics Forum | Fri Jun 03 05:40:02 EDT 2005 | Mighty C
Good Morning Everyone, Is anybody using Valor to program Mydata's or any other platform? I'm just looking for some real world feedback. Thanks In Advance MC
Electronics Forum | Fri Jun 03 08:16:13 EDT 2005 | Base
OK Rob, got the message ... =;0] Cheers, Base (by the way: my 'Home Shopping channel' remark was inspired by the enthusiasm of the author, not by any experience with the software itself.)
Electronics Forum | Tue Jun 07 12:00:51 EDT 2005 | jdengler
I think if you represent an equipment manufacturer or reseller you should ALWAYS preface any comments you make about equipment with your affiliation. This way everyone can judge your comments. Jerry
Electronics Forum | Thu Jun 02 09:55:33 EDT 2005 | james
So far this is what I found and have not had any problems since. There was a big chunk of the belt torn halfway off and I had to cut part of it. Also there was a connector loose on one of the boards. Thanks for all of your advice.
Electronics Forum | Tue May 31 10:58:31 EDT 2005 | davef
There are a host of possibilities. Virtually any fabrication process prior to outer layer manufacturing prior to HAL could contribute to dewetting. That goes all the way to excessive brighteners in the copper plating line. Anything that prevents the