Electronics Forum | Fri Dec 17 09:40:03 EST 2010 | davidmartin
Thanks guys.... I have the same issues here. We have just moved our entire plant into another, so everything has to be verified. Would anyone recommend any particular actions be taken to verify or validate equipment setups? SMT, wave and selectiv
Electronics Forum | Wed Dec 15 17:42:50 EST 2010 | ck_the_flip
We do not have capabilities with our current PCB layout software to generate a pick and place file and/or centroid data. Consequently, we are teaching all centroids at the machine. Are there any software tools or utilities that can take a basic ger
Electronics Forum | Tue Dec 28 20:49:08 EST 2010 | wingding
We have an ERSA 500 and we need to pull the Pump Housing. The manual is pretty limited and it doesn't offer any information on how to remove it. Do we have to remove all of the solder from the pot first? Or is there some way to pull it without going
Electronics Forum | Thu Jan 06 23:07:48 EST 2011 | essohn
Hello~ I need your expoertised experience. Do you have any experience of Saponifier influence on Al pad for wire bonding. We have a porblem of no wire bonding in use of saponifier in order to remove clean type flux. thanks in advance
Electronics Forum | Tue Jan 11 20:38:45 EST 2011 | pdl
Hi Guys Has any one got a copy of Autoprogram they would share with me just got a Quad 4c machine and it only have the Control software. thanks Pete
Electronics Forum | Fri Jan 14 04:47:42 EST 2011 | dilogic
I've asked before, but got no response. Maybe this time I'll have more luck. So, can anybody tell me if EPC5 CPU can be replaced with EPC9 without any hardware mods on the VME rack?
Electronics Forum | Mon Jan 17 17:20:40 EST 2011 | dyoungquist
The cut can be as close to the component as you want as long as you do not damage the component or any surface mount pads/traces/through holes/internal pcb planes etc.
Electronics Forum | Mon Jan 24 07:05:55 EST 2011 | cbeneat
I've never had any problems, occasionally left a message, but they return calls promptly. For reflow support, J is the man...call main number and ask for him.
Electronics Forum | Wed Jan 19 14:43:51 EST 2011 | davidalvarez
Im looking for manuals + schematics and repair information for an electrovert omniflo 7e reflow oven manufactured in 1999, also intrested in the Bill Of Materials if available. Any information on where these can be obtained and where replacement part
Electronics Forum | Thu Jan 20 08:08:24 EST 2011 | deanm
Because we build Class 3 assemblies, our company has formal inspection steps on our routes. CCA's go through surface mount and then an operator inspects the solder joints for defects and corrects them (touch-up). Following this they go to formal insp