Electronics Forum | Tue May 21 21:36:10 EDT 2002 | rwilliams
I'd like to hear from anyone regarding the use of Data-PAQ's new Rapid Oven Set-Up software. This looks ideal for our low volume, high mix environment. Anyone having any comments good or bad would certainly be appreciated. Thanks, Ron
Electronics Forum | Tue May 28 17:02:46 EDT 2002 | dougt
I've had problems with this in the past, pretty sure it was due to age. Had a couple of old reels of dummy parts that would not allow for any type of stretching of the cover tape. I have also seen where the cover tape appears to shrink and it pulls
Electronics Forum | Tue May 28 18:34:43 EDT 2002 | brooke627
I am a student just wondering how solder is manufactured. If anyone knows any links or books that explain the process simply, it would be of great assistance. I am told that the process is easier seen than explained, but right now, I cannot get to a
Electronics Forum | Tue Jun 04 11:14:48 EDT 2002 | ckd
Hi All - My question is how do solder balls form and stay in the vias? The assembly goes thru SMT top placement, reflow then thru hole components mounts on top side as well. The board is sent thru the wave solder process. Has anyone experienced this
Electronics Forum | Tue Jun 04 18:30:49 EDT 2002 | arzu
We want to perform a "design of experiments" session to determine the optimum settings for our pasteprinter.We will design a stencil with decreasing aperture-sizes to make it measurable where the printing stops. The result should be a measureable pri
Electronics Forum | Fri Jun 07 03:33:35 EDT 2002 | seje
Thanks pals, that will be helpfull. If someone have a AXI on the floor, I'd be thankful to have any opinions and data, cuz "In god we trust all others bring data", so I'd like to have some opinions from users too, not only from salesmans :) Have a n
Electronics Forum | Tue Jun 11 06:43:28 EDT 2002 | pjc
If your goal is to inspect solder joints then X-ray is the way to go. AOI is not effective at solder joint and is best at component inspection. Using an AXI or AOI for solder joint inspection requires a lot of engineering time. Don't know any good si
Electronics Forum | Wed Jun 12 06:27:39 EDT 2002 | seje
Pete & Ken Thanks guys. So it's getting clear that AXI programming and fine tunig takes a lot of time, and that's something that we don't have too much to spend. Next question will be, that can anyone recommed any automatical inspection system for h
Electronics Forum | Thu Jun 06 08:23:56 EDT 2002 | caldon
I have not seen any, but that does not mean they do not exist. I do know lead-free is starting to loose its momentum. Compliance dates are being pushed back. And also some of the European standards developments are starting to make exceptions (i.e. m
Electronics Forum | Fri Jun 07 02:43:35 EDT 2002 | madreindeer
Thanks for answers....In Euroland (My place)it is not so clear.And this is confusing: There is 3 different comittee�s in Europe. First says 1 of January 2007.Second says 1 of January 2006, and third one says that any of these will do. Also we get a