Electronics Forum | Mon Jan 23 08:15:33 EST 2006 | pavel_murtishev
Good day, Vibratory (MultiStick) feeder is bottleneck of any placement machine. If you feed expensive IC�s via vibratory feeder they surely will be damaged. If you really care about expensive IC�s equip you placement machine with reject conveyor. In
Electronics Forum | Wed Jan 18 12:59:53 EST 2006 | jeffharley
We are starting a lead free line. My question: Is there a contamination issue with running lead free boards and lead boards after soldering through the same board wash machine? I would expect not it, but want to know if anyone has any experience with
Electronics Forum | Wed Jan 18 14:53:38 EST 2006 | Mike gipos
Hi all, Anybody can help us to find out which of these reflow owens is possible to convert to Pb Free: 1.Panasert REF-A 2.Universal Full Spectrum IR Reflow 150 3.Hollis Surf FCR310 4.Panasonic 2632 Which one is the best and which one is the nea
Electronics Forum | Wed Jan 18 16:03:08 EST 2006 | Klevesqu@vtc.edu
Hello, I am wondering where I can purchase and read up on the specs for the proper solder flux pastes for Luxeon emitters. I notice in there aplication briefs they mention 380SR-flux gel and a few others but I no clue if that is a model number or wha
Electronics Forum | Tue Jan 31 03:53:50 EST 2006 | chadnugent79
We use an alignment jig {from Fuji I believe} that checks any rotational offets from the shaft to the head. The bottom of the jig fits onto the head while the top slides around the top "what I call" the crown gear. I've had several instances where
Electronics Forum | Thu Mar 30 07:41:44 EST 2006 | cyber_wolf
I do not reccomend spraying anything into those clutches. There is a greased bearing in there that cannot run dry. Also there is a very specific way to dismantle the clutches, and it does not require a 5.5 mm wrench in any part of it. Dax, if you
Electronics Forum | Mon Jan 23 10:06:17 EST 2006 | GCO
I would like to say sharing new parts only, it seems that we have a little problem teaching new BGA's or CSP's with actual vision system (very time consumming). - see FUJI site for an add-on off line unit if needed ($$$...HIC!). Any better solution o
Electronics Forum | Thu Jan 19 20:40:52 EST 2006 | Gary Kemp
We are experiencing a blistering problem during our process of lead free assembly. The customer has supplied us with the bare fab rated at 140 Tg. I am under the assumption that the Tg rating should at minimum be 170. Does anyone know if there is
Electronics Forum | Fri Jan 20 12:23:08 EST 2006 | stepheniii
Get a FAST computer. Especially if you are programming for the MSF. I didn't like the old panapro and havn't used the new one much. But from what I did see, it's much improved even if it takes a long time to optimize programs. Put it on the fastes
Electronics Forum | Sat Jan 21 22:33:17 EST 2006 | gipos
Hi all, Maybe someone have experience with Vitronics -Universal FULL IR Reflow oven 4816. We have to make choise between above IR and Panasert REF-A? Maybe some Electrovet is better than both of them ? Any opinion will be very much appreciated. Mi