Electronics Forum | Thu Sep 19 16:58:04 EDT 2002 | dragonslayr
You definitely need to have live demos of each system, using your specific assembly if you want to compare apples to apples. Each of the AOI OEM's you mentioned have plus amd minus to their unique systems. You will need to evaluate your specific nee
Electronics Forum | Thu Apr 19 18:03:56 EDT 2018 | spikesnpearls
hello i am a new aoi programmer and i was wondering how to choose/change what type of lighting it uses while scanning the board.i use a yestech ytv-fx
Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker
Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of
Electronics Forum | Mon Mar 29 12:10:14 EDT 2010 | rway
Test Jet will work for catching lifted leads, certainly. X-ray is the only thing for testing for internal solder defects such as voids and cracks. I personally do not have any experience using X-ray, so I cannot advise on its reliability. Perhaps
Electronics Forum | Mon Jan 10 18:35:05 EST 2011 | eadthem
Ive used a Mirtec machine for 3 years MV3L with side angle inspection. Mirtec has some issues documentation, and repair plus. But there machine is impressive and the AOI software is good. We can find about 90-99.99% of all errors using just the 5
Electronics Forum | Fri Apr 01 14:51:23 EDT 2011 | jaimebc
We are currently experiencing a high rate of false calls on our 0402 chips. Resistors for the most part. Has anybody out there found a setting where this false calls are minimized? We are using top red light, pattern inspection,color inspection ( wh
Electronics Forum | Fri Apr 01 18:32:51 EDT 2011 | frcdave
Dback, Some questions for you: 1. Are you using the red light configuration for better contrast on the 0402 parts? 2. Is your system fitted with both low and High Magnification cameras? Have you spoken with the guys at YESTech? Their phone support i
Electronics Forum | Mon Apr 04 11:27:07 EDT 2011 | fishingfool
Dback, Most likely shouldn't have color inspection on. Using red light colors will look the same so you gain nothing by using this. What exactly are you getting as false calls? Sounds like you have lots of things going on in this type of inspect
Electronics Forum | Thu Apr 19 20:01:30 EDT 2012 | eadthem
some things to consider, Is there flux on the board. are there finger prints on the tops of parts. Is the board warped at the V score from reflow Is the board shifting in the machine during inspection. These are the issues we have had with our mir
Electronics Forum | Fri Apr 20 14:11:27 EDT 2012 | rway
Programming is different, yes, but so is the terminology. ///with machine vision you have parameters that select what is good and what is bad, and you have parameters that help make bad look worse and good look better making the difference between w