Electronics Forum: asked (Page 1 of 333)

waVE SOLDER BATH

Electronics Forum | Thu Apr 20 10:09:34 EDT 2006 | Chunks

Ask Soltec. Ask the guy you bought the machine from for them. Find out who owned before you - ask them for it. Ask Wave Master Larry.

Looking for KME Controller

Electronics Forum | Thu Jun 05 12:47:36 EDT 2003 | arturoflores

Ask Tekmart (check its internet site) they should have the KME spare you are asking for.

What should you ask question before hiring contractor

Electronics Forum | Wed Feb 12 06:57:53 EST 2020 | hifzakhan

What should you ask question before hiring contractor?

Mirtec AOI Max Component Height

Electronics Forum | Wed Apr 23 11:28:11 EDT 2008 | jdengler

Did you ask Mirtec? When we were ready to buy a Mirtec they asked if we needed more than normal clearance height. I do not know if this would be retrofitable but maybe you could ask. Jerry

Introduction and Guidance Request for a New Member

Electronics Forum | Tue Jun 11 15:17:16 EDT 2024 | tey422

Welcome! Electronic Forum is where the people ask questions & to search for answers. Feel free to ask any SMT related questions, but try to be as specific as possible so it's easier to get directly to the answer you are expecting. Just a note, depen

Re: cleaning glue off of stencils

Electronics Forum | Wed Mar 08 09:32:57 EST 2000 | Dane Stokes

We use loctite to print with before begining testing on printing we asked loctite for the best cleaning solvent for there product. loctite had there own solvent that was designed to break down the propertys of their glue mix. Contact glue supplier an

Re: cleaning glue off of stencils

Electronics Forum | Wed Mar 08 09:32:57 EST 2000 | Dane Stokes

We use loctite to print with before begining testing on printing we asked loctite for the best cleaning solvent for there product. loctite had there own solvent that was designed to break down the propertys of their glue mix. Contact glue supplier an

What pressure is recommended to clean AMT boards after reflow

Electronics Forum | Fri Sep 07 15:46:38 EDT 2001 | davef

Now that I've blabbered to the edge of coherency [chicks and too many Krispy Kreams make me do that], let me ask ask the salient question. What's an "AMT board"?

Epoxy Push Test Specifications

Electronics Forum | Thu May 30 11:19:29 EDT 2002 | Hussman69

Ooops, my bad. "Curse your eyes Nell, for even asking a question on this forum. Check the archives before we put a curse on your adhesive process and force you to ask another question!" Whew, hope that made up for my mistake.

SMT process Blowhole/ Pinhole

Electronics Forum | Sun Mar 30 20:21:44 EST 2003 | iman

we are using a "recommend supplier profile", and we have gotten back to the talking table with them over this profile specs. Thanks for the pointer, have ask them on this issue. Have also asked for their phase-transistion diagram to understand their

  1 2 3 4 5 6 7 8 9 10 Next

asked searches for Companies, Equipment, Machines, Suppliers & Information