Electronics Forum | Wed Feb 08 04:08:35 EST 2006 | fctassembly
Hello Greg, I agree with you that the article in SMT Magazine should be studied very carefully as it contains many errors in respect to SN100C. The testing performed was a DOE and was not an optimized run. There is also a statement on dross generatio
Electronics Forum | Mon Feb 13 10:33:57 EST 2006 | fredericksr
Hello, I am automating a process on our floor from wire solder hand application to dispensed paste and reflow. The process involves "lidding" a shielding lid around our assemblies for microwave quieting. The result is non-hermetic. For cosmet
Electronics Forum | Wed Mar 08 14:11:38 EST 2006 | mholz
I am looking for an industry standard �stock� note to place on our printed circuit board assembly drawings that will capture a level of cleanliness for an IPC-A-610 class 2 board assembly. I�m looking for some quantitative spec for cleanliness that w
Electronics Forum | Fri Apr 21 09:07:50 EDT 2006 | Timothy
My company is currently using point source soldering of SMT components. We have seen some problems due to improper soldering and are looking to switch to a reflow oven/hotplate assembly. Our PCB's range in size but are no larger than 5"x5" and we as
Electronics Forum | Sun May 28 19:02:11 EDT 2006 | grantp
Hi, One thing, getting back to the original topic, is you might want to panelize these boards as much as possible, as you don't have too many components, but you have some good volume. So the machine changeover time is going to be an issue. Althoug
Electronics Forum | Fri Jun 09 15:46:34 EDT 2006 | samir
I say: �Wave flux needs to be heated to certain activation temps which won't be repeatedly achieved with a manual soldering process. Plus, you won't burn off any residual activator as you would if the board were immersed in a solder bath.� Muse say
Electronics Forum | Tue Jun 13 04:46:15 EDT 2006 | AR
Has anybody else noticed a problem with Assembl�on's mechanical 12 mm feeders, with 4 mm pitch? We are experiencing grave pickup problems with a MELF diode packed this way and fed with this type of feeder. If I attach a hefty weight to the blister ta
Electronics Forum | Tue Jul 18 16:40:09 EDT 2006 | dphilbrick
We have a system where when we set up the line to run a job before the first part is placed an auditor verifies we have all the correct parts loaded on the machines in thier correct locations. We then run a first article. The board is inspected to in
Electronics Forum | Sat Aug 12 20:47:50 EDT 2006 | Efren
Hi Guys, A few months ago I posted a question about a New Assembly Line, and It was great the answers I received. Now I would like to have an additional advise, to complete the requirements of my financial. We expect to install approximately 6 Pick
Electronics Forum | Fri Nov 03 11:06:13 EST 2006 | rgduval
The process that burnt the tips up yesterday was hand soldering/touch up of lead-free assemblies. Not even assembly, but just touching up boards that we've soldered on a solder pot...which will lead to another question. We're using SAC 305 WS482 3