Electronics Forum | Tue Feb 28 18:49:28 EST 2023 | joekirin
Are you gluing these components by chance? I had an assembly where a glue dot was slightly too big and it pulled to the outside of the components solder joint. This looks eerily similar.
Electronics Forum | Mon Jun 19 14:17:09 EDT 2023 | daniel_stanphill
Understood, but I do not think you will find anyone who gives a standardized rule across all components. Different components will have different restrictions. At a minimum you need to determine what is the most sensitive component on your BOM and a
Electronics Forum | Thu Jun 29 04:50:42 EDT 2023 | SMTA-70263692
This looks like it could be related to oxidation.Do you per-bake your pcb before assembly to remove any moisture inside your board panel?
Electronics Forum | Sat Oct 07 12:52:11 EDT 2023 | ttheis
I don't know why you would NOT use a no clean paste. You're just adding time and cost to the assemblies, not to mention potential problems. Changing paste is the best option here unless you have a very compelling reason not to.
Electronics Forum | Fri Nov 03 21:16:40 EDT 2023 | calebcsmt
Depending on the assemblies you're producing, I highly recommend 8.9HF from Indium for a low residue SAC305 alloy. We have been using this for years in our NC process and residues are very little, with appropriate stencil apertures and paste printing
Electronics Forum | Tue Feb 10 06:29:45 EST 2015 | sarason
Ask the question in the Yahoo Zevatech group, It has many experienced Zevatech/Juki Users. https://ca.groups.yahoo.com/neo/groups/zevatech/info My program PCBSynergy will program this machine. pcbsynergy.com regards Sarason
Electronics Forum | Thu Nov 09 15:33:27 EST 2023 | SMTA-64387381
Looking for recommendations for an SMT supplier (both SMT and through-hole capabilities) in the Greenville, SC area. The product portfolio is high mix, and low volume. We would kit/supply materials, so we are only looking for assembly capabilit
Electronics Forum | Wed Dec 06 12:35:10 EST 2023 | stephendo
Most of our LEDs are assembled as individuals connected by PCB traces. The ones that aren't are triple LEDs with three colors.
Electronics Forum | Wed Dec 06 12:41:07 EST 2023 | jdengler
We make PCB assemblies for an RGB arc that is made up of multiple curved PCB's that have connectors on the ends to plug together. I think the end the radius of the arc is 2 feet. Jerry
Electronics Forum | Wed Feb 28 17:20:25 EST 2024 | jdengler
Find out were the excess flux is coming from. See if it can be eliminated or reduced at the source. Lokely coming from something other than SMT assembly.