Electronics Forum | Mon Apr 19 20:54:34 EDT 2004 | dave
Rob: We're never heard of paste related problems caused by humidity that is too low. Low humidity is very expensive to control. So, when you think about all the assembly used to be done in the Bay Area. You'd think there would be more talk about i
Electronics Forum | Wed Apr 21 10:37:34 EDT 2004 | russ
Only the manufacturer of this part can tell you if subjecting the entire assembly through reflow temps is okay. It is not a good assumption that "if a part can be hand soldered it can withstand reflow" there are many connectors/headers/buzzers/etc
Electronics Forum | Fri Apr 23 08:20:25 EDT 2004 | babe
Sometimes solder balling is related to oxidized paste or paste that has sat on the pcb too long before reflow. Mostly it is related to process, sorry... Too slow or too fast of a reflow ramp rate. Heating up an assembly too quickly will not allow the
Electronics Forum | Wed May 19 09:32:28 EDT 2004 | Mr Fix it - MPM
Sounds to me like the driver for the tactile is not working. The tactile has three components to it. The first is the switch, the second is the pneumatic up/down actuator and the third is a small motor in the tactile assembly. The motor has a driv
Electronics Forum | Wed Apr 28 12:16:09 EDT 2004 | paul_bmc
We usually make a template offline to put with the assembly file. When it is time to run, place the pin support template in the machine, place your pins and your ready to go. Probably about a 15 sec setup. We looked into the ready-e-set pin suppor
Electronics Forum | Tue May 11 09:50:04 EDT 2004 | vickt
Grant,You should take a look around at all of the alternatives out there. There are many fine solutions from every SMT assembly vendor. Fuji is not the only game in town. You should not purchase on name brand alone. If you are considering the CP-7, I
Electronics Forum | Wed Jun 09 16:52:16 EDT 2004 | Cary Chang
Dear Mira: I had some assembly operation in Manuas before, You can find out the company name and telephone number in the attached web address. From the telephone list of the Manuas electronics companies which you can call them. some of them you can c
Electronics Forum | Mon Jun 14 23:12:32 EDT 2004 | Rodion Pronin
Hello Ricardof I believe speaking of your example, huge boards with many components on them, a very important aspect would be the sequence in which you place your components on the board... It happends that I have a software that optimizes assembly
Electronics Forum | Thu Jun 17 07:04:03 EDT 2004 | davef
It sounds like the parts are not soldering properly [have poor solderability]. This probably due to corroded nickel underplate caused by: * Nickel that oxidized, while awaiting overplating * Poor quality tin overplate, allowing nickel to oxidize aft
Electronics Forum | Wed Jun 16 21:56:04 EDT 2004 | rodionp
For those who are not sure as to what exactly we do, please get familiar with the article: http://www.reed-electronics.com/semiconductor/index.asp?layout=article&articleid=CA71291&industryid=3026 Which is PCB Assembly Optimization, what we do is we
