Electronics Forum | Tue Jul 19 15:43:37 EDT 2005 | msjohnston1
We are trying to do a dispenser comparison study between the Asymtek Axiom X1020 with DJ9000 valve and the Camalot XyflexPro system. The system will have a dual purpose for dispensing epoxy dots and underfill. I would like to have comments positive
Electronics Forum | Fri Apr 06 08:45:48 EDT 2007 | davef
UNDERFILL The design of the component and the end-use environment drive the requirement fot underfill. Here is a good introduction: http://www.asymtek.com/news/articles/2002_globaltronics_csp_and_fcuf.pdf Google for more. We have no relationship, n
Electronics Forum | Fri Jan 27 17:23:10 EST 2006 | muse95
Watch the solder profiles allowed for these caps. Most electrolytics cannot withstand high heat. Even RoHS compliant Electrolytics are often rated for peak 245C, 3 secs max, for example. Nowhere close to the 260C 10-20 sec you usually like to see.
Electronics Forum | Mon Jan 17 14:03:45 EST 2005 | davef
There's a fair amount of information on underfilling CSP and flip chip in the web. Look here to get started: * http://www.asymtek.com/news/articles/2002_globaltronics_csp_and_fcuf.pdf * http://www.smta.org/knowledge/proceedings_abstract.cfm?PROC_ID
Electronics Forum | Wed Jan 09 15:24:49 EST 2002 | mregalia
Thanks Chris. As I was writing my last message our mailperson dropped off the latest issue of Circuit Assembly. It has an article on mixing SMT and COB on the same board. The author recommends as a compromise 10-20 micro inches of gold over 70-100 of
| 1 |
A leader in automated fluid dispensing, jetting, and conformal coating. Products include stand-alone dispensing workstations and fully automated, in-line conveyorized systems with advanced process controls.
2747 Loker Ave. West
Carlsbad, CA USA
Phone: 760-431-1919
