Electronics Forum | Mon Jun 19 11:16:22 EDT 2023 | eurolan
Hi guys, we managed to fix it. This tool turned out to be impossible to find. What we did is mount the motor, mark the timing belt's position and loosen the screws that attach the timing belt to the head. This way we were able to move the position of
Electronics Forum | Thu Aug 31 04:56:44 EDT 2023 | auriga2001
I would start with the following possibilities and solutions: Add extra solder to the pads with a Camalot dispenser; or preformed solder slugs placed as an additional component if there is enough extra pad to attach it without interfering with compo
Electronics Forum | Mon Apr 08 15:07:56 EDT 2024 | tey422
To me, it seems like there are slightly XY offset. Hydra might be able to pick up the tips, but not all the way securely attached to the hydra tubes. So, when the tips put back are not fully seated, which causing the tool stick inside the bank. You
Electronics Forum | Tue Aug 22 10:22:59 EDT 2000 | Wolfgang Busko
Mark: The fact that these daughter boards have to be attached to the TSOP-footprints is what makes the thing difficult cause they will be greater than the original part. One could think that a LCC-design allows for proper routing. But when it comes t
Electronics Forum | Mon Dec 20 19:09:54 EST 1999 | Chris
If your flex circuit is only populated on one side, you can have the PCB vendor palletize the flex for you. What you do is have the flex circuit laminated to 062" FR4 using a thermoset adhesive like Dupont WA. Standard flex circuit adhesive. Howev
Electronics Forum | Thu Jul 22 12:05:33 EDT 1999 | John Thorup
| | Which among the two profiling method is more reliable/accurate in getting the oven thermal profile? | | | | a) using a HIGH-TEMP solder wire then soldering the thermocouples onto the profile points of the board (e.g. component lead etc.) | | |
Electronics Forum | Thu Jun 17 20:57:44 EDT 1999 | Earl Moon
| Does anyone have experience with placing heat sinks on BGAs? I have limited experience with PSA (pressure sensitive adhesives)heat sinks, and am interested with the possibility of a clip-on device. I am specifically concerned with ease of assembl
Electronics Forum | Wed Jun 16 07:46:45 EDT 1999 | Glynn Technologies and Manufacturing
| We are a medium sized PCB assy. house manufacturing about 2000 motherboards a day. There is a major problem we are facing at the wave soldering stage, i.e. warpage of the PCB. As soon as the PCB touches the wave it warps severely from the centre
Electronics Forum | Mon Apr 26 16:06:32 EDT 1999 | Chrys Shea
Hey - remember the evaluation of VOC-Free fluxes that I promised a couple of months ago? well, I finally scrounged up the time to remove the propreitary (board name and number) info from the report. So it's ready. I posted it in the SMTnet library
Electronics Forum | Mon Apr 26 21:29:34 EDT 1999 | Dave F
| Hey - remember the evaluation of VOC-Free fluxes that I promised a couple of months ago? well, I finally scrounged up the time to remove the propreitary (board name and number) info from the report. So it's ready. I posted it in the SMTnet libra
