Electronics Forum | Mon Jul 31 21:33:58 EDT 2006 | seth
What is the distance from the reader to the segment, and can you use a filler gauge to set the gap or is there a special tool needed?
Electronics Forum | Wed Aug 02 15:19:29 EDT 2006 | SWAG
Sounds like air pressure is set O.K. The next thing to check is that the platen surface that the x and y axis ride on is perfectly clean. After that, you should knock the camera off the platen and make sure that all of the small air nozzles are blo
Electronics Forum | Fri Sep 22 11:51:32 EDT 2006 | chris g
Have you tried doing a short diagnostic test? That will check the repeatability and backlash of the axis. Did you use the C-tool when calibrating the camera?
Electronics Forum | Tue Dec 19 03:40:38 EST 2006 | aj
I had this happening before. It is a simple adjustment on the Z-axis belt. Basically the dog is not making the sensor correctly and driving on further. I think you have a lot more issues if the shaft was damaged. aj...
Electronics Forum | Wed Dec 20 17:00:29 EST 2006 | aj
Have you contactd your Fuji Engineer for advise. I would really look at the z-axis belt setup before investing that sort of money. We had the exact problem here and that is all it was. aj...
Electronics Forum | Wed Dec 20 17:03:50 EST 2006 | aj
By the way , changing the ball screw will also sort your problem out because you will have to carry out the Z-axis setup ( belt tension etc ) as part of the change. so it is worth a shot to carry out the setup and see how it goes! you will have nothi
Electronics Forum | Mon Jan 08 19:52:14 EST 2007 | fastek
A soft limit error is an error due to trying to drive the head outside it's mechanical limits. Check your X-axis program data for this part.
Electronics Forum | Thu Jan 18 14:02:51 EST 2007 | geb
Thanks for your help everyone. For some reason it has started working again, without altering the program or settings!!?? So I don't actually know why it has done this. Thanks again, Grant
Electronics Forum | Thu Feb 15 12:45:44 EST 2007 | chrisgriffin
If you think you are having lighting issues, you should do a histogram test. It's under the test user. There is a pot on a power supply that will adjust the brightness. The power supply is right next to the Y axis motor. There should be a brown p
Electronics Forum | Thu Mar 01 18:24:37 EST 2007 | jaimebc
Set FEEDER AXIS in the box of the label ALTERNATE MODE at the OPERATION DATA display. ( to get there go to PROGRAM EDIT/OPERATION DATA/ then press next page. For reference look in your operation manual 3.7 ALTERNATE MODE.
