Electronics Forum | Thu Feb 17 15:14:27 EST 2005 | OverTheHill
Ah,ha,ha,ha,ha,ha.....Ah,ha,ha,ha You guys are killing me !!!!!!!!!!! Let's get serious folks. O. Tarango, Tarango, Tarango. Every once in a while the earth has been known to wobble on it's axis. You were probably trying to build a board during th
Electronics Forum | Fri May 06 15:15:19 EDT 2005 | lyrtech
Hi, I have an INTERMITENT error on my FUJI IP-2 that cause to me many headaches. The error is " SERVO NOT GOOD". In the books, it means that it is relative to servo amplifier. But I can't assume that is the problem because sometimes the machine wor
Electronics Forum | Thu May 19 08:32:46 EDT 2005 | geb
I have a Universal GSM. Does anyone know the maximum width, between the conveyor rails, that a PCB can be. The GSM had an "Axis PWC error", which I think is down to the board width being too wide. This time I was able to halve the board width from 2
Electronics Forum | Mon Jun 13 15:54:20 EDT 2005 | peter ng
Our technical side facing the printing shifted at the Sony SP750 Printer.It happened randomly exspecially when the printing X axis offset is more than 1.5mm.We using the Cad fiducial mark at our programme but the problem still remain.We need some ad
Electronics Forum | Mon Jun 20 18:36:42 EDT 2005 | jsloot
Does anyone have any experience with a QUAD Meridian 1010? Our company has purchased a used machine. We have it installed and running almost smoothly. Getting an error code 3487, description is "Z axis target position in motion board is strange" Anyo
Electronics Forum | Fri Jul 15 02:26:47 EDT 2005 | fastek
OK...here's another one. The HiE designation began with UP-2000's I believe. And if I'm not mistaken the difference between a HiE and a non HiE was speed improvements as it related to axis movement times. If you could figure out a way to accomplish t
Electronics Forum | Tue Jul 19 12:03:34 EDT 2005 | cyber_wolf
CLampron, There is no place for PCB thickness in a Mydata program. The board thickness is of no consequence.(As long as the thickness is uniform across the entire board) When you run a program, the Z axis touches the surface of the board to determin
Electronics Forum | Mon Sep 26 14:09:08 EDT 2005 | slthomas
"Note: nothing changed to the process, the problem come out of sudden." Did this happen with a batch of boards you'd been running a while, or was it a new batch (lot/date code)of boards? I'd be inclined to suggest that the environment that your my
Electronics Forum | Tue Oct 11 18:21:36 EDT 2005 | stepheniii
Does it do nozzle changes at a different speed than the programs? It's been a while since I worked on these beasts. I"m wondering if it can handle slow speeds but at full bore it can't handle it. Maybe try one part with everything set to slow speed
Electronics Forum | Tue Oct 25 22:50:16 EDT 2005 | KEN
What is the (initial position) ratio of pulse counts to home encoder pulse (relative to the home sensor). It should be 50% +/- 15% Run this test several times in between a warm up. I bet your numbers are all over the place. I bet you have a loos
